GainSpan GS1011MEE-DB Manual do utilizador - Página 2

Procurar online ou descarregar pdf Manual do utilizador para Placa-mãe GainSpan GS1011MEE-DB. GainSpan GS1011MEE-DB 12 páginas. Serial to wi-fi evaluation kit

Imprimir página

VALUATION

OARD

This section describes the various interfaces and jumper settings for the GS1011MxP-EVB board.

Feature

RF Module

RF Output Power (Typical)

Antenna Type

I/O Port (J1 or J2)

LED

WPS Switch (SW2)

Alarm Switch (SW4)

Program Switch (SW3)

On/Off Switch (SW1)

Serial Select Jumper ( J4)

Sensors

Power Source Select (J9)

Battery

Power Mode (J8)

Power Measurement Jumper (J8)

Power Supply Header

Power Source Range

RELIMINARY

ETAILS

Program

6-pin UART

Switch

Connector

Serial Select

LEDs

Jumper

GS1011MxP

Module

Temperature

Alarm

On/Off

Power

Sensor

Light

Switch

Supply

Sensor

Header

Power Mode

Description

GS1011MIP – Internal PA and PCB antenna or

GS1011MEP – External PA and PCB antenna

9 dBm with GS1011MIP

18 dBm with GS1011MEP

On-board PCB Trace (GS1011MxP)

J1: 6-pin serial UART ( 3.3V TTL) or

J2: RS232 DB9 Connector

2 LED's to indicate state

Push button for Wi-Fi Protected Setup

Push button for Alarm and configuration

RUN: Normal Operation (default)

PROGRAM: For programming the GS1011M module:

Power on/off switch

1-2 : RS232 Interface (DB9)

2-3: 6-pin UART (default)

Temperature and Light

1-2: Ext Lab DC power supply

2-3: Battery (default)

Two 1.5V AA Battery (Alkaline or Lithium)

Lithium is recommended for longer battery life

1-2: Always On (Power is always on)

2-3: Standby Mode (Power is turned off to the board during standby state) - default

Jumper to facilitate measurement of current consumption for module

Jumper posts for connecting Lab DC power supply

2.7V to 3.6V

AGE

Serial to Wi-Fi Start Up Guide

RS232

DB9

Connector

Power

WPS

Source

Switch

Select

Battery

Holder

ONFIDENTIAL