DB Research SPA6.1M Manual do utilizador - Página 7

Procurar online ou descarregar pdf Manual do utilizador para Amplificador DB Research SPA6.1M. DB Research SPA6.1M 8 páginas.

(

SPA6.1M , SPA12.1D, SPA15.1D )

SPA6.1M , SPA12.1D, SPA15.1D

etwork that allows you to select the crossover mode (Highpass—Full Range) and desired

crossover point for channels 1 and 2. Channels 3 and 4 allow you to select between a

Highpass 12db slope, a 12db Stereo Lowpass / Bandpass slope and a mono 24db Lowpass /

Bandpass slope. For example if you wish to drive a pair of subwoofers on channels 3 and 4

out the high frequencies with a 24db slope. You will then need to adjust the Lowpass

control to the desired frequency setting (make sure to have the Highpass control set to

switch to LP/BP stereo. Once the LP/BP stereo switch setting is selected you will use both

any unwanted low frequencies with a 12db slope.

(

SPA6.1M , SPA12.1D, SPA15.1D )

SPA6.1M , SPA12.1D, SPA15.1D are equipped with a variable 24dB Slope

feature a variable Bass Boost EQ is set at 45Hz. In some subwoofer enclosure installations it

may necessary to use the Phase Shift feature. The Phase Shift button sets the Subwoofer

subwoofer enclosure. All SA

mono amps are also equipped with Multi-Linking technology.

When using a single SA mono amp set the Master / Slave switch to the Master position.

the slave setting the front panel controls become inoperative. All adjustments for both

Multi-Link

Diagram

RCA input

Slave controls are void

Select Master

Master Amp

Master controls

Slave Amp

Select Slave

2 ohm minimum