Gait up PhysiGait Lab Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Instrumentos de medição Gait up PhysiGait Lab. Gait up PhysiGait Lab 18 páginas. User manual and outcome parameters

Imprimir página

3.3

Walk

Gait Up's PhysiGait Lab system can be used to measure various walking tests, the system

is designed for logged gait tests of various length and protocol such as 20m gait test, 6min

walk test or a figure-of-eight test. When measuring several different protocols or conditions

it is recommended to generate one sensor file for each, that is: start and stop the recording

for each test or refer to heel strike times.

3.4

Stop the recording

To stop the recording push the main button of the sensors for about 3 seconds.

In order to have the synchronisation of the sensors at the end of the measurement in

firmware v1.0.4, you need to turn off the "slave" sensor first. This is the sensor that

remained green for some time at the beginning of the recording and which has a text file

called "slave.txt" on the internal memory. When pushing the main button, the LED will be

green and turn orange (red and green LED on), this is the moment when you can release

the button. The "slave" sensor displays the green LED on until it has received the

synchronisation from the "master" ("Finalizing" on the illustration below) after which it turns

off (with 3 rapid green blinks to mark successful data recording). You can then turn off the

"master" sensor in the same way, push the main button until the LED becomes orange and

then release the button.

For later firmwares (v1.1.0 upwards, released June 2017) it is not necessary to stop the

slave sensor first and wait for synchronization, the sensors can be turned off in any order.

When pushing the main button, the LED will be green and turn orange (red and green LED

on), this is the moment when you can release the button. The sensors turn off with 3 rapid

green blinks to mark successful data recording.

Between each start and stop of recording one file is created and stored on the internal

memory of the Physilog®5.

3.5

Start the recording from the smartwatch

Alternatively to the recording using the button of the sensors, it is possible to control them

from the remote control smartwatch application. To open the app, press the lower right

button of the included smartwatch.

PhysiGait Lab user manual v1.3.1 Date: 29.04.2019

EPFL Innovation Park, Bat C. CH-1015 Lausanne

Gait Up SA

www.gaitup.com

TVA CHE-145.136.760