Hidro-Water XENA 10.1 Manual do utilizador e do instalador - Página 2

Procurar online ou descarregar pdf Manual do utilizador e do instalador para Sistemas de filtragem de água Hidro-Water XENA 10.1. Hidro-Water XENA 10.1 13 páginas.

Imprimir página
INDEX
1.- INTRODUCTION ..........................................................................................................3
2.- PRECAUTIONS AND WARNINGS ............................................................................3
3.- CHECKING THE CONTENTS ....................................................................................4
4.- INSTALLATION ...........................................................................................................6
4.1.- Faucet installation (Figure-3) ....................................................................................................... 6
4.2.- Water inlet installation (Figure-8 & Figure-9) .............................................................................. 6
4.3.- Drain clamp installation (Figure-7) .............................................................................................. 7
4.4.- Cartridge installation .................................................................................................................... 7
4.5.- Membrane installation .................................................................................................................. 8
4.6.- Osmosis system installation ....................................................................................................... 9
5.- OSMOSIS SYSTEM START-UP ...............................................................................12
6.- INSTALLATION AND MAINTENANCE ...................................................................13
6.1.- Procedure for replacing cartridges and the membrane. ........................................................... 14
8.- MONITORING AND MAINTENANCE CONTROL ..................................................18
9.- SPARE PARTS ..........................................................................................................20
MA-EN-OSMOSIS XENA10.1-RO-0220-22-FLC-21-V01.0
2
1.- INTRODUCTION
This manual explains the installation and operation of equipment for water treatment by reverse
osmosis for household use. The equipment has been designed to be connected to the housing facility.
It is easy installation and operation as it has already been semi-assembled. It requires very little
assembly as it is only necessary to connect the hydraulics, electrics and install the faucet as indicated
in point 4 of this manual.
In the absence of installation and maintenance as described in this manual by technically
qualified personnel to ensure the quality of water produced and proper installation, the
warranty is void.
2.- PRECAUTIONS AND WARNINGS
Please read this manual carefully following the warnings listed below before going ahead
with the installation and use of the XENA 10.1 osmosis system. If you have any doubts, please
contact your distributer.
•
For the correct operation of osmosis systems with a pump, the pressure should be between
1 and 3 bars, for this reason a pressure regulator has been supplied with the system to
be installed at the system inlet. In doing so, this will avoid damaging the pump and other
components of the system.
•
The temperature of the water to be treated should not be below 5ºC nor above 35ºC to avoid
damaging the system.
•
The osmosis system is designed to treat tap water with a maximum salinity of 1000 ppm. Do not use
in places where the water is not microbiologically safe or has an unknown quality. For water with a
greater salinity level, please contact your distributor.
•
It is advisable that the water to be treated has been softened or with a maximum hardness of
15ºHF for optimum performance. Water with a hardness greater than 15ºHF will shorten the life
of the membrane.
•
If the water has a high concentration of iron or magnesium, nitrate concentration greater than 100
ppm, sulphate concentrations greater than 250 ppm, more than 3 NTU turbidity and/or prolonged
use of high chlorine levels, please contact your distributor to suggest an appropriate pre-treatment
system to ensure the correct operation of the system.
•
The osmosis system reduces the level of the following elements; aluminium, ar-senic, bromoform,
chlorine, chlorides, copper, conductivity, chrome, dibromo-chloromethane, fluorides, nitrates,
oxidability, pH, selenium, sodium, sulphates, PAHs, trihalomethanes and other dissolved solids.
•
If the osmosis system is not going to be used for a long period of time, close the water passage.
•
Install the system on a flat surface.
•
Do not expose the system to direct sunlight or install it outdoors.
MA-EN-OSMOSIS XENA10.1-RO-0220-22-FLC-21-V01.0
3