Gakken Stirling engine Instruções de montagem e de utilização - Página 8

Procurar online ou descarregar pdf Instruções de montagem e de utilização para Brinquedo Gakken Stirling engine. Gakken Stirling engine 12 páginas.

Imprimir página

Figure ー

How to turn on and off the control levers.

Confirm the operation

Every lever turns on

and switching of each

when lowering and

lever with the right

turns off when raising.

diagram.

Every lever turns on

when lowering and

turns off when raising.

Figure ー

Turn off the lever 1 and

lever 2 and turn on the

lever 3. Put the gauge to

the piston part and adjust

Adjustment of the height of the shaft of the

the height so that the tip

displacer.

of the gauge comes to the

upper part of the piston

Put the gauge

(but not the cylinder). Turn

to the upper part

the screws at both sides

of the piston to

adjust the height.

equally to adjust the

height. Check the center

at times looking from the

gear side. Adjust the

height so that the shaft

comes straight from as

near the center as

possibly can.

Figure ー

Put two AA batteries in the

battery box (pay attention to

piston

the direction!) and connect it

with the motor connecter.

Check the condition by

pushing forward the flywheel

with a finger as shown in the

Figure ー . If it moves

gauge

smoothly, the position is

almost right. If it moves

Adjustment of the displacer and the piston.

heavily, you need more

adjustment. Find the right

position until the displacer

start moving automatically by

turning the screws at both

sides little by little. (Fine

motor connecter

adjustment is needed. Turn

the hinder

part

the screws less than a round

at a time.) The displacer

moves faster in proportion as

the shaft become level with

the stand. Find the place

where it moves as fast as

possible.

lever 3 (for the generator)

lever2 (for the fan)

OFF

lever1 (for the wheels)

Check the center

Hold the engine in the

hand and look from the

gear side to check the

center.

When the height is

adjusted properly,

the flywheels move

smoothly.

piston

gauge

lever

Adjust the height

with this screw and the

one at the other side.

cylinder

displacer

the fore part

battery box

(for two AA batteries)

Figure ー

Attach the glass cylinder.

After adjusting the

position to move the

displacer faster,

disconnect the battery

box from the motor

the

connecter and then

hinder

connect the lamp

part

connecter and the motor

connecter. Then screw

and set the glass cylinder

paying attention not to

break the displacer.

Figure ー

How to adjust the position of the displacer.

Adjust the position of

the shaft of the

displacer while

pushing forward the

flywheel with a finger

so that the metallic

part at the end of the

displacer slightly

touches to the end of

the glass cylinder.

Adjust the length

of the shaft.

the hinder

part

Attach the E8 propeller.

Figure ー

Attach the E8

propeller to the D2

propeller lever.

propeller lever

the hinder part

Warning ★ Fire is used for the experiment. Use great caution to avoid

a burn and fire. Do not let a 15 or less-year-old child experiment alone.

radiator

the fore part

body

Move the displacer adjuster to the position

where the end of the displacer slightly touches

to the end of the glass cylinder while pushing

forward the flywheel with a finger.

displacer

The displacer doesn't

move well if it is pushed

too much to the end and

crushed. The adequate

condition is to touch the

end softly.

body

the fore part

propeller

displacer

glass cylinder

the fore part

body