ADEMCO VISTA-20SE Manual do utilizador - Página 6
Procurar online ou descarregar pdf Manual do utilizador para Painel de controlo ADEMCO VISTA-20SE. ADEMCO VISTA-20SE 9 páginas. 2-partitioned security system
Também para ADEMCO VISTA-20SE: Formulário de programação (8 páginas), Manual do utilizador (4 páginas), Formulário de programação (8 páginas)
Imprimir página
To Activate Devices
Enter security code then press [#] + [7] + then enter the number representing the device you wish to activate.
To Deactivate Devices
Enter security code then press [#] + [8] + then enter the number representing the device you wish to deactivate.
Security Codes
As an additional safety feature, other users who do not have a need to know your code can be assigned different
security codes. These secondary users are identified by "user numbers," which are selected when assigning a user's
security code. You can assign up 14 additional user codes (user numbers 03-16), including the babysitter and duress
codes. Note that the master (primary) user of the system is the only one who can assign codes to secondary (or
temporary) users, and is user number 02; user number 01 is reserved for the installer of the system.
All codes can be used interchangeably when performing system functions (a system armed with one user's code can be
disarmed by another user's code), with the exception of the babysitter code.
Babysitter Code
This code can be used to arm the system in assigned partitions, but cannot disarm the system unless the system was
armed with this code. This code is typically assigned to someone (such as a babysitter) who has a need to arm/disarm
the system only at certain times. The babysitter code is assigned to user 15. The user of this code should not use
the Quick Arming feature described below.
Duress Code
This feature is intended for use when you are forced to disarm or arm the system under threat. When used, the system
will act normally, but can silently notify the alarm monitoring company of your situation, if that service has been
provided. Duress code is assigned to user 16.
Important: This code is useful only when the system is connected to an alarm monitoring company.
Quick Arming
Note that if "Quick Arming" was programmed by the installer, the [#] key can be pressed in place of the security code
when arming the system. The security code must always be used to disarm the system, however.
Important: Temporary users of the system (e.g., babysitters, cleaning staff) should not be shown how to use any system
function they do not need to know, such as bypassing protection zones for example.
Sequential key depressions for all steps in a procedure must be made within 2 seconds of one another, or else the entire
entry is aborted and must be repeated from its beginning (e.g., perform steps 1, 2, and 3 below with no delay between
steps).
To Add a User or Change a User's Code:
1. Enter master code then press CODE key.
2. Enter the two-digit User Number (03-16) for the user you are adding or changing.
3. Enter the new four-digit security code for that user.