Celestron NexStar 6 SE Manual de configuração rápida - Página 3
Procurar online ou descarregar pdf Manual de configuração rápida para Acessórios Celestron NexStar 6 SE. Celestron NexStar 6 SE 4 páginas. Nexstar hand control
Também para Celestron NexStar 6 SE: Manual do Protocolo de Comunicação (8 páginas)
Imprimir página
Before you can begin using your NexStar 6SE or 8SE, you must setup your computerized hand control and
go through the SkyAlign alignment procedure. In order for the NexStar to accurately point to the objects in
the sky, it must first be aligned with known positions (stars) in the sky. With this information, the telescope
can create a model of the sky, which it uses to locate any object in its database
1
Turn power switch (located at the base of
the fork arm) to "on"position.The light will
come on and the hand control will
display "NexStar SE" .
4
Use the hand control direction arrow
buttons to point telescope at a distant
land object, like a telephone pole or at
night you can use the moon. Center and
focus the object in the 25mm eyepiece
of the telescope.
7
Power Switch
Once you have aligned your finderscope,
make sure to turn off the LED light to
conserve the battery. Now you are ready
to align the telescope. This will have to
be done at night.
10
The hand control will display the last
entered time and site information. Since
this is your first time using the NexStar,
press UNDO to enter your site and time
information.
2
You will notice that there are directional
arrows in the center of the hand control.
These only move the telescope. They
cannot be used to scroll through
menu features.
5
In order to accurately center an object
in the eyepiece it may be necessary to
change the slew speed of the motors.
To change the slew speed, press the
RATE button then select a number from
1 (slowest) to 9 (fastest).
8
When the display reads NexStar SE, press
ENTER to begin the alignment
procedure.
11
Press ENTER to select City Database. Use
the Up and Down scroll buttons (located
on #6 and #9) and choose the closest city
to your present location. Press ENTER after
selecting the country, state and city.
Hand Control Guide
3
Power Switch
Now you will need to align the finderscope.
Turn on the red LED light by turning the
knob shown above. When used for the first
time,remove the clear plastic disk that is
located between the battery clip and the
battery.See inset.
6
With the object centered in the eyepiece,
use the azimuth (right/left) and altitude
(up/down) adjustment knobs on the
finderscope to place the red alignment
dot directly over the centered object.
9
Use the UP and DOWN scroll buttons
(located on #6 and #9) to select
"SkyAlign" then press ENTER. Now
you will need to enter your site/time
information.
12
Using the numeric key pad enter your
time information. Press ENTER to
continue. Press UNDO to backspace.