Celestron 47007 Manual do utilizador - Página 2
Procurar online ou descarregar pdf Manual do utilizador para Estação meteorológica Celestron 47007. Celestron 47007 3 páginas. Large format lcd personal weather station with wireless remote sensor
Também para Celestron 47007: Instruções de utilização (15 páginas)
s
o
ettings anD
Peration oF the
Indoor and Outdoor Temperature and Humidity –
the indoor temperature and humidity as well as the
outdoor temperature and humidity is shown on the
LCD display.
Data displayed in "C" or "F" – push the "DOWN"
arrow button (when in a normal mode) to change
from "C" (Centigrade) or "F" (Fahrenheit) for the
display you desire.
Clock and Calendar – Press the "MODE" button
and hold down for a few seconds to enter the setup
mode. Use the "+" or "-" buttons to make changes.
Press the "MODE" after each setting is correct.
The settings in sequence will be – hour / minute /
seconds / year / month / day / time zone / weekday
language / exit. The weekday language to choose
is available in English, German, French, Spanish,
Italian, Dutch, and Danish.
The clock format can be 12 or 24 hour mode – use
the "+" button (in normal mode) to change the
format that you wish to use. The time zone is for
setting normal time to a ± 12 hour difference.
Temperature Alert – you can set a range of indoor
and outdoor temperature alerts (high and low). In
normal mode press the "ALERT" button once, and
it will display an icon that the alert is enabled (to
the left of the indoor and outdoor temperature)
and press again, and the icon will be removed to
indicate the alert is disabled. To set the maximum
and minimum temperatures for the alert, hold
the "ALERT" button down for a few seconds and
an icon (top part) will flash to tell you to set the
maximum temperature alert – use the "UP" and
"DOWN" arrow buttons to choose your alert indoor
temperature and push the "ALERT" button to set.
r
eCeiver
Push the button again, and the lower icon will flash,
and you will set the minimum indoor temperature
alert. Repeat the same setup again, but when the
top icon is flashing with no temperature displayed,
push the UP arrow button to make the settings for
the outdoor temperature. When the temperature
reaches the alarm stage, the icons will flash and
make a sound.
Alarm Setting – push the "MODE" button to enter
the alarm mode. Press and hold the "MODE" button
a few seconds and set the hour and minute of the
alarm using the "+" and "-"buttons and confirm
the data by pressing the "MODE" button. Press
"MODE" to show the alarm time and the "AL" icon
will be displayed briefly. Press the "AL" to have a
bell appear (in the clock display area), meaning the
alarm is enabled. To turn the alarm off (disable),
press "AL" again, and the bell icon will disappear. To
stop the alarm, press the "+" or
"-" or "AL".
Channel – if your Sensor is set correctly to Channel
1, you will have the LCD display for the outdoor
temperature and humidity. If you do not have an
outdoor temperature and humidity display, push and
hold the "SEARCH" button until you hear a beep,
and the display should show up in a few seconds.
Placement – the Receiver can be placed on a table,
desk, or other flat surface, or it can (by using a
hanger cut out on the rear of the Receiver) be hung
on a wall or other location.
Reset – if for some reason the LCD display does not
function properly and you are using new batteries,
use a pin (or other very small object) to press the
"RESET" button on the rear of the Receiver.