Automotive Data Solutions TR2350AK Manual do Proprietário - Página 9
Procurar online ou descarregar pdf Manual do Proprietário para Arrancador remoto Automotive Data Solutions TR2350AK. Automotive Data Solutions TR2350AK 16 páginas.
Imprimir página
1. Insert a 25 cent coin into the hollow corner of your iDatastart remote.
2. Gently twist the coin until the casing pops open.
3. Use your coin to pry open the rest of the case perimeter.
4. Carefully remove the circuit board from the case.
5. Slide the old battery out of its enclosure and replace with the new battery.
6. Carefully replace the circuit board into bottom half of the casing.
7. Snap top and bottom casings back together using your hands.
ADJUSTING ENGINE RUNTIME SETTINGS
Once remote started from your factory key fob or long-range remote, your vehicle will run for the programmed
'runtime' setting. The default runtime is 15 minutes but it can also be programmed for 3, 5, 10, 25, 30 or 35
minutes. If you wish to change your remote start runtime setting, contact your iDatastart Authorized Dealer.
KEY TAKEOVER FOLLOWING REMOTE START
Available on push-to-start models only, the 'key takeover' procedure ensures that your engine does not turn off
when entering the car during the remote start runtime, following a remote start command.
Follow the instructions below:
For Push-To-Start Vehicles
To prevent your vehicle from shutting down, complete the steps below within 45 seconds:
1. Unlock and enter vehicle with valid smartkey
2. Close doors
3. Press foot brake
4. Press and hold the START button for 2 seconds
For Standard Key Vehicles
2022-02-19 © Automotive Data Solutions Inc. 9/15
TR2350AK