HiFiMAN HM802s Manual do Proprietário - Página 4

Procurar online ou descarregar pdf Manual do Proprietário para Leitor multimédia HiFiMAN HM802s. HiFiMAN HM802s 10 páginas. High-resolution portable music player

Imprimir página

Basics

Using HM802s

Note

Please read this manual thoroughly on how to best install and operate your

player for many years of enjoyment.

Card Installation

The HM802s will automatically detect and update the files in the

SD card after the player is turned on. The time for detection depends on the size of the

files on the SD card. After the update, the HM802s will be ready to play.

To Remove SD Card

Choose "Remove SD Card" from the Main Menu. Wait until

you see "Please remove the SD card". The SD card is then safe to be removed.

Power ON/OFF/Stand by

Hold the power key on the right side of HM802s up for

3 sec. After releasing the power key, the player will power on and the HIFIMAN logo will

appear.Push the power key up when the player is powered on, it will enter Stand by

mode.Under Stand by mode, push the power key up for 3 sec, the player will be on.Go

to Setting and select Power OFF to power the player off when the player is powered on.

Note: Even under Stand by mode, the player still consumes electricity. Using a

fully-charged battery can last seven to eight days if the player is in Stand by mode.

If you will not listen to the player for a long period of time, please power it off.

HM802s Owner's Guide

Operation

Other information

Basics

Operation

Reset

Should the player LCD become "frozen", carefully insert a fine-point pen or needle in

the reset hole to reboot the player.

Charging

The average battery life of HM802s is nine hours. Please charge the player when you

see a reminder of low power. We recommend that you use the original HIFIMAN charger.

Note: 1.The player can only be charged fully with Power OFF or under Stand by mode.

2.It cannot be charged via a USB port.

Replacing the Battery

How to replace the cover back:

How to remove the back

cover of HM802s:

1.Insert the back cover to fit in the two latch holes on the

1.Remove the screws on

top.(Pictures 1).

the bottom (shown in red

2.Make sure the back cover falls into place along the frame.

circles).

Fit in the two latch holes on the bottom (Pictures 2 and 3).

2.Gently lift the back cover.

1.Slightly press the back cover down. Check if it is securely in

place without any slant (Pictures 4 and 5).

2.Replace the two screws on the bottom (Picture 6).

When your battery is out of life, you should replace it with a new one which can only

be supplied by HIFIMAN or HIFIMAN authorized dealers. For more information on

replacing the battery, please visit: http://head-direct.com/

HM802s Owner's Guide

Other information