Dynamite DYN4065 Manual de operação - Página 3

Procurar online ou descarregar pdf Manual de operação para Carregador de bateria Dynamite DYN4065. Dynamite DYN4065 7 páginas. Passport dc li-po 6s charger

Imprimir página

DYN5003

Charge Adapter Tamiya Female: Losi Micro

DYN5004

Charge Adapter Tamiya Female to Losi Mini

DYN5005

Charge Adapter Banana to Tamiya Male

DYN5006

Charge Adapter Banana: Deans Ultra Male

DYN5007

Charge Adapter Banana: EC3 Female

www.DynamiteRC.com

DYN5008

Charge Adapter Banana: EC5 Female

DYN5010

12V DC Power Adapter with Cig Plug

available Balance adapters

You may also purchase adapters to adapt

Thunder Power and Losi balance plugs to fit the

Dynamite balance charge sockets.

DYN5012

A dapter Cables-THP, DYN

Balancer, 2–6S

DYN5011

A dapter Cables-LOS, DYN

Balancer, 2–5S

Passport DC Li-Po 6S Charger

input Power Connection

DC Voltage

Connect the red banana plug to the positive

(+) terminal of an 11–14-volt DC power supply.

Connect the black banana plug to the negative

(-) terminal.

NOTE: When the input power is connected,

the last battery chemistry and current setting

LEDs will illuminate.

When the charger has been connected to the

power source properly, the LED will blink

in order from lA to the Status LED (from

right to left) and then stop at the last charge

rate setting. The Battery Type LED will also

illuminate.

to Change Battery type (Chemistry)

Press and hold the Start/Select button for 2

seconds to change battery type from Li-Po

to Li-Fe while the output battery pack is not

connected.

NOTE: The Battery type LED will light red for

Li-Po battery and green for Li-Fe battery.

Charge output Battery Connection

Choose the appropriate charge cord to match

your battery pack and connect the positive

(red) lead to the positive (+) output terminal.

Connect the negative (black) lead to the

negative (-) output terminal.

warning: Always make sure that you

follow proper polarities at all times or electrical

shock will occur.

Passport DC Li-Po 6S Charger

Balance Plug Connection

Connect the balance plug to the appropriate

balance socket on the front side of the charger.

Use a balance adapter if necessary.

NOTE: The charger will not charge the battery

unless the balance lead is connected.

The beeper will sound and the Status LED

will flash red if you start charging without

connecting the balance-charge lead.

Press and hold the Start/Select button for 2

seconds to reset.

Charge Mode

1. Set the current rate before charging.

Adjustable charge rates from 1–5A.

2. See the table below to select the charge rate.

Li-Po/Li-Fe batteries should be charged at a

1C rate which is 1 times the capacity.

Example: battery capacity (1000mAh) x 1 =

1000mA or 1 amp)

Battery Capacity Charge Rate

Charge Time

1300mAh

78–94 Min.

2200mAh

54–65 Min.

3300mAh

40–48 Min.

NOTE: You must also consider the battery

pack's series cell count (i.e. 2S, 3S, 4S, etc...)

as the voltage of the pack being charged will

affect the available charge current in order to

not exceed the 50 Watt maximum output limit

of the charger (1-5A for 2S pack; 1-4A for 3-4S

pack; 1-2A for 5-6S pack).