Galanz 11030002 Manual do utilizador - Página 5

Procurar online ou descarregar pdf Manual do utilizador para Forno micro-ondas Galanz 11030002. Galanz 11030002 15 páginas.

Imprimir página
Make sure that all the packing materials
1.
are removed from the inside of the door.
Check the oven for any damage, such
2.
as misaligned or bent door, damaged
door seals and sealing surface, broken
or loose door hinges and latches and
dents inside the cavity or on the door. If
there is any damage, do not operate the
oven but contact qualified service
personnel.
This microwave oven must be placed
3.
on a flat, stable surface to hold its
weight and the heaviest food likely to be
cooked in the oven.
Do not place the oven where heat,
4.
moisture,
or
generated,
materials.
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces risk of
electric shock by providing an escape wire for the electric current.
WARNING Improper use of the grounding plug can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the grounding instructions are not completely understood,
or if doubt exists as to whether the appliance is properly grounded, and either:
1) If it is necessary to use an extension cord, use only a 3-wire extension cord that has a 3-blade
grounding plug and a 3-slot receptacle that will accept the plug on the appliance. The marked rating of
the extension cord shall be equal to or greater than the electrical rating of the appliance, or 2) Do not
use an extension cord. If the power supply cord is too short, have a qualified electrician or serviceman
install an outlet near the appliance.
ELECTRICAL REQUIREMENTS
The electrical requirements are a 120 volt 60 Hz, AC only, 20 amp. It is recommended that a separate

INSTALLATION GUIDE

high
humidity
or
near
combustible

GROUNDING INSTRUCTIONS

For correct operation, the oven must
5.
have sufficient airflow. Allow 20cm of
space above the oven, 10cm at back
and 5cm at both sides. Do not cover or
block any openings on the appliance.
Do not remove feet on which oven
stands.
Do not operate the oven without glass
6.
tray, roller support, and shaft in their
proper positions.
Make sure that the power supply cord is
7.
undamaged and does not run under the
oven or over any hot or sharp surface.
8.
The socket must be readily accessible
so that it can be easily unplugged in an
are
emergency.
4