Galanz D100N32MSLDRIIV-HG Manual de instruções - Página 15
Procurar online ou descarregar pdf Manual de instruções para Forno micro-ondas Galanz D100N32MSLDRIIV-HG. Galanz D100N32MSLDRIIV-HG 16 páginas.
Imprimir página
1.
Press AIR FRY pad once.
2.
Press MENU/TIME/WEIGHT dial or START pad once.
3.
Turn the MENU/TIME/WEIGHT dial to select temperature.
4.
Press MENU/TIME/WEIGHT dial or START pad once.
NOTE: During cooking, you can add cooking time by pressing +30 SEC pad.
C
HILD LOCK
The child proof lock prevents unsupervised operation by little children.
To set the child proof lock: Press and hold LOCK/TURNTABLE OFF pad more than 3 seconds, the
indicator light will come on. In the lock state, all pads are disabled.
To cancel the child proof lock: Press and hold LOCK/TURNTABLE OFF pad more than 3 seconds, the
indicator light will come off.
T
URNTABLE
During cooking, the turntable is default working. You can turn the turntable on or off by pressing
LOCK/TURNTABLE OFF pad.
NOTE: Sometimes the turntable may become too hot to press. Be careful to touch the turntable.
F
AILURE DIAGNOSE
Failures
An error sign "Er10" display.
An error sign "Er11" display.
An error sign "Er12" display.
An error sign "Er13" display.
An error sign "Er30" display.
An error sign "Er40" display.
An error sign "Er41" display.
An error sign "Er42" display.
An error sign "Er43" display.
An error sign "Er44" display.
An error sign "Er45" display.
An error sign "Er46" display.
An error sign "Er47" display.
An error sign "Er48" display.
An error sign "Er49" display.
An error sign "Er60" display.
An error sign "Er61" display.
An error sign "Er81" display.
An error sign "Er82" display.
High temperature alarm.
Low temperature alarm.
Open circuit alarm.
Short circuit alarm.
Inverter failure.
Inverter input under voltage.
Inverter input over voltage.
Over current protection.
Over temperature protection.
Magnetron fault.
Surge protection.
High voltage fault.
Switch tube fault.
Communication fault.
Auxiliary power supply.
Sensor fault, open circuit or short circuit.
Sensors selection is out of range.
Displayer communication transmission fault.
Displayer communication receiving fault.
14
Possible reasons