Hifonics MT OLYMPUS CYCLOPS 3K Manual do produto - Página 5
Procurar online ou descarregar pdf Manual do produto para Amplificador Hifonics MT OLYMPUS CYCLOPS 3K. Hifonics MT OLYMPUS CYCLOPS 3K 13 páginas. Mt olympus
Imprimir página
C. ODIN 2K & CYCLOPS 3K
8
aMPLIfIer aPPLICatIONS
Interconnect cable checklist:
A MONO signal source is suggested, such as would be available from the mono – sub bass output of an
active crossover, whether stand alone, or built into a head unit or equalizer.
IMPOrtaNt:
Do not be tempted to connect the hot, or positive outputs, from any source together
to obtain a mono signal, as this could very well damage the output stage of that source. It is not
necessary, but recommended, to feed the SAME signal to both left and right inputs via a Y-adapter
RCA cable. Connect the mono speaker positive terminal to the RIGHT +, and its negative terminal
to LEFT -.
Control setting checklist:
»
LEVEL: Minimum (7 oclock)
o
PHASE: 0
(7 oclock)
»
BOOST: 0 (7 oclock)
»
»
WIDTH: Half (12 oclock)
»
CENTER: 45Hz (10 oclock)
»
SUBSONIC: 25Hz (12 oclock)
LPF: 80Hz (11 oclock)
»
MODE: MST
»
SINgLe aMP INStaLLatION PrOCeDure
1.
Connect the amp LINE INPUTS to the Radio/CD player full range or mono line outputs with good quality
RCA interconnect cables.
2.
Plug the HFR-G1 remote module into the amp remote input DIN connection.
3.
Route a power cable (4-gauge for Odin 2K / 0-gauge for Cyclops 3K) directly to the vehicle battery with
an in-line fuse.
4.
Connect a ground (4 or 0-gauge) cable directly to chassis ground within 18" of the amplifier.
•
Be sure to remove any paint or primer from the ground point.
•
Use a nut, bolt and lock washer to secure the ground cable to the chassis ground.
5.
Connect the subwoofer(s) in accordance to the diagrams below.
6.
Make sure the MASTER/SLAVE switch is in the MST position.
NOte:
The amplifier will not work if the MASTER/SLAVE switch is in the SLV position
ODIN 2K, CYCLOPS 3K
INPUT
OUTPUT
LEVEL
L
L
9V
0.2V
R
R
CYCLOPS 3K
POWER INPUT
+12V
ODIN 2K
GND
REM
POWER
INPUT
Minimum final loudspeaker impedance:
MASTER
REMOTE
PROTECT
PHASE
BOOST
WIDTH
CENTER
SUBSONIC
LPF
MODE
OUT
MST
SLV
POWER
0
180
0
10dB
30 100Hz
15
35Hz
35
250Hz
BASS EQ
SLAVE IN
SEE OWNERS MANUAL
Designed and Engineered in the U.S.A.
FOR DIAGNOSTIC CODES
SPEAKER OUTPUT
GND
REM
FUSE
+12V
50
50
SPEAKER
OUTPUT
1 Ohms mono
9