Autonics Ai-M-42SA Manual - Página 11
Procurar online ou descarregar pdf Manual para Controlador Autonics Ai-M-42SA. Autonics Ai-M-42SA 16 páginas. Pulse train input type, servo system, dc type
Imprimir página
两相步进电机马达样本闭环步进电机驱动器说明书 韩国Autonics步进伺服马达选型样本pdf资料
AiS Series
Motor Installation
1. Mounting direction
Motor can be mounted in any directions-facing up, facing down and side ways. No matter which direction motors to be mounted, be sure
not to apply overhung or thrust load on the shaft. Refer to the table below for allowable shaft overhung load / thrust load.
Overhung
load
※ 1: The distance from the shaft in front (mm)
Permissible overhung load [kgf(N)] by distance from shaft tip (mm)
Motor size
D=0
Ai-M-42 Series
2 (20)
Ai-M-56 Series
5.6 (55)
Do not apply excessive force on motor cable when mounting motors.
Do not forcibly pull or insert the cable. It may cause poor connection or disconnection of the cable.
In case of frequent cable movement required application, proper safety countermeasures must be en-
sured.
2. Mounting method
●Ai-M-42 Series
±0.1
31
[Mounting plate]
●Ai-M-56 Series
±0.1
47.14
[Mounting plate]
±0.1
47.14
[Mounting plate]
With considering heat radiation and vibration isolation, mount the motor as tight as possible against a metal panel having high thermal conduc-
tivity such as iron or aluminum.
When mounting motors, use hexagon socket screws, hexagon nuts, spring washers and flat washers. Refer to the table below for allowable
thickness of mounting plate and using bolt.
Q-12
奥托尼克斯电子中国autonics电机热线 4006-022-002
Side ways
※1
D
D=5
2.5 (25)
6.8 (67)
Ø3.5
(Through hole)
Hexagon socket
+0.021
Ø22
0
Pilot for flange
(Counter bore
or Through hole)
Ø4.5
(Through hole)
Pilot for flange
(Counter bore
or Through hole)
+0.3
Ø38.1
+0.1
M4
(Tap hole)
+0.3
Ø38.1
+0.1
Thrust
load
D=10
D=15
3.5 (34)
5.3 (52)
9.1 (89)
13.3 (130)
Tap hole
Spring
washer
screw (M3)
Hexagon socket screw (M4)
Through hole
Through
hole
Pilot for flange
(Counter bore
or Through hole)
Tap hole
Facing up, down
Thrust
load
Allowable thrust load
Under the load of motor
Mounting plate
(thickness: Min. 4mm)
Hexagon nut
Spring
washer
Mounting plate
(thickness: Min. 5mm)
Spring
washer
Hexagon socket
screw (M4)
Mounting plate
(thickness: Min. 5mm)
深圳 北京 上海 株洲 天津 青岛
(unit: mm)