909 DWL850 Manual de instruções - Página 9
Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica 909 DWL850. 909 DWL850 12 páginas. 600w dowel joiner
Imprimir páginaBevel guide locking knob
Loosen the bevel guide locking knob (10) before adjusting
the bevel angle and retighten it when you have made the
adjustment.
Perspex window
The three lines on the window
(11) in the bevel guide (9) show
the position of the centre of
each drill bit and the mid-point
between them. They are used as
a guide when drilling to marks
made on the work piece to
designate the desired position of
the holes.
Face plate
Hold the face plate (12) firmly and flush against the work
piece when drilling.
Gripper pins
The gripper pins (13) are spring
loaded to help stop the tool from
moving laterally during operation.
If you feel that there is a chance
that the gripper pins might
scratch your work, rotate the pins
approximately a quarter
of a turn and push them back
behind the face plate.
Note.
One pin turns to the right and the other to the left.
Depth guide
The drilling depth can be
adjusted between
0 and 40mm by setting the
position of the
depth guide (14) to the desired
value.
Depth guide locking knob
Loosen the locking knob (15), move the depth guide (14)
and retighten the locking knob (15).
Zero marker
The position of the zero marker
(16) can be adjusted using a
small flat screwdriver to prise it to
the left or right.
Edge guide
The edge guide (17) can be
used to adjust the distance of the
holes from the edge of the work
piece.
Continuous adjustment is
possible between approximately
7mm and 42mm.
Edge guide ratchet knob
The ratchet knob (18) allows fine adjustment of the
movement of the edge guide.
Edge guide locking knob
Loosen the locking knob (19),
move the edge guide (17) and
retighten the locking knob (19).
Note.
Do not attempt to turn
the ratchet knob (18) whilst
the locking knob (19) is in the
tightened position. It could
damage the ratchet mechanism.
9