909 OSC400 Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Ferramenta eléctrica 909 OSC400. 909 OSC400 16 páginas. Oscillating multi-tool

produce the smoothest surface.

It is recommended that the dust extraction system is used

when sanding.

Using the scraper blade

1. Install the scraper blade on the multi-tool.

2. Set the speed control wheel to #4 and turn the switch ON.

When using the scraper blade to scrape old finishes or glue

from a workpiece, place the under side of the blade flat on

the workpiece surface and then lift upward on the rear of the

tool to allow the blade to form a very slight angle with the

workpiece surface. Feed the blade slowly into the material

that is to be removed. Do not force the tool as slower travel

speeds will produce better cutting action and reduce the risk

of gouging the workpiece.

When using the scraper blade to cut carpet, place a scrap

workpiece under the carpet where the cut is being made.

Set the speed to "MAX", turn the tool so the scraper blade

is at right angles (perpendicular) to the carpet and then feed

the blade into the carpet.

WARNING:

When servicing, use only identical replacement

parts. The use of any other part may create a hazard or

cause product damage.

DO NOT use solvents when cleaning plastic parts. Plastics

are susceptible to damage from various types of commercial

solvents and may be damaged by their use. Use a clean

cloth to remove dirt, dust, oil, grease etc.

WARNING:

Do not allow brake fluids, gasoline, petroleum-

based products, penetrating oils, etc. to come into contact

with plastic parts. They contain chemicals that can damage,

weaken or destroy plastic.

DO NOT abuse power tools. Abusive practices can damage

the tool and the workpiece.

WARNING:

DO NOT attempt to modify tools or create

accessories. Any such alteration or modification is misuse

and could result in a hazardous condition leading to

possible serious injury. It will also void the warranty.

All of the bearings in this tool are lubricated with a sufficient

amount of high-grade lubricant for the life of the unit under

normal conditions. Therefore, no further lubrication is

required.