909 10CSMS Manual de instruções - Página 14

Procurar online ou descarregar pdf Manual de instruções para Serra 909 10CSMS. 909 10CSMS 20 páginas. 15 amp 10" 254mm single bevel laser guided slide miter saw

Imprimir página

Setting the fence square with the table

1. Make sure that the electrical plug is removed from the

power point.

2. Push the saw arm (4) down to its lowest position and

engage the release knob (6) to hold the saw arm in the

transport position.

3. Loosen the miter lock (24).

4. Rotate the table (20) until the pointer is positioned at 0º.

5. Tighten the miter lock (24).

7. Using the 6mm hex key provided, loosen the four screws

securing the fence (18) to the base (Fig. a).

8. Place a square against the fence (18) and alongside the

blade (Fig. b).

9. Adjust the fence (18) until it is square with the blade.

10. Tighten the screws securing the fence (18).

11. Loosen the Phillips head

screw holding the pointer

of the miter scale (21)

and adjust it so that it

accurately indicates the

zero position on the miter

scale (Fig. c).

12. Retighten the screw

securing the miter

scale pointer.

13. Replace the top section of the fence and secure the

hex screw using the 6mm hex key.

Changing a blade

DANGER!

Never try to use a blade larger than the stated

capacity of the saw. It might come into contact with the

blade guards. Never use a blade that is too thick to allow the

outer blade washer to engage with the flats on the spindle.

It will prevent the blade screw from properly securing the

blade on the spindle. Do not use the saw to cut metal or

masonry. Ensure that any spacers and spindle rings that

may be required suit the spindle and the blade fitted.

1. Make sure that the electrical plug is removed from the

power point.

2. Push down on the operating

handle (6) and pull the

release knob (5) to

disengage the saw arm (4).

The release knob (5) can be

turned so that it is held in the

retracted position (Fig. d).

3. Raise the saw arm (4) to

its highest position.

4. Using a Phillips head

screwdriver loosen and

remove the screw that

secures the guard retraction

arm (12) to the rotating

blade guard

(Fig. e).

5. Using a Phillips head

screwdriver loosen and

remove the screw that

secures the blade bolt

cover (13) (Fig. f).

6. Pull the rotating blade

guard (11) down then

swing it up together with

the blade bolt cover (13).

When the rotating blade

guard (11) is positioned