909 255DB Manual de instruções - Página 13

Procurar online ou descarregar pdf Manual de instruções para Serra 909 255DB. 909 255DB 20 páginas. 2000w 255mm (10") single bevel laser guided slide mitre saw

Imprimir página

Setting the table square with the blade

1. Make sure that the electrical plug is removed from

the power point.

2. Push the saw arm (4) down to its lowest position and

engage the release knob (6) to hold the saw arm in the

transport position.

3. Loosen the mitre lock (24)

(Fig. T).

4. Rotate the table (20)

until the pointer is

positioned at 0º.

5. Tighten the mitre lock (24).

6. Loosen the bevel lock (15)

and set the saw arm (0) at

0º bevel (the blade at 90º to

the mitre table). Tighten the bevel lock (15) (Fig. U).

7. Place a set square against the table (20) and the flat part

of the blade (Fig. V).

Note.

Make sure that the square contacts the flat part of

the saw blade, not the teeth.

8. Rotate the blade by hand and check the blade-to-table

alignment at several points.

9. The edge of the set square and the saw blade should

be parallel.

10. If the saw blade angles away from the set square,

adjust as follows.

11. Use a 13mm wrench or adjustable wrench to loosen

the lock nut securing

the 0° bevel adjustment

screw (33) (Fig. W). Also,

loosen the bevel lock (15).

12. Adjust the 0° bevel

adjustment screw (33)

with the 6mm hex key to

bring the saw blade into

alignment with the square

(Fig. X).

13. Loosen the 2 Phillips head screws holding the pointer

of the bevel scale (16) and adjust the position of the

pointer so that it accurately indicates zero on the scale

(Fig. Y). Retighten the screw.

14. Retighten the bevel lock (15) and the lock nut securing

the 0° bevel adjustment screw (33).

Note.

The above procedure can also be used to check the

angle of the saw blade to the table at the 45º bevel angle

(Figs z & a).