Galaxy DX 2527 Manual do Proprietário - Página 9
Procurar online ou descarregar pdf Manual do Proprietário para Transcetor Galaxy DX 2527. Galaxy DX 2527 10 páginas. Am/fm/ssb/cw/pa amateur base station transceiver
Imprimir página
1. Press the PRG (Program) button.
2. Press the SCAN button. ("PRG SCAN+" should appear in
the lower right corner of the display window.)
3. Using the SHF button and UP and DOWN arrows, select
the upper scan limit, then press ENT.
4. Press the SCAN button again. ("SCAN-" should appear in
the display window.)
5. Using the SHF button and UP and DOWN arrows, select
the lower scan limit, then press ENT.
The upper and lower scan limits have now been programmed.
To activate the scan feature, return the radio to manual
operation and press the SCAN button. If the display shows
"SCAN+", the radio will scan from the lower limit to the
upper limit. If "SCAN-" is displayed, the unit will scan from
the upper limit to the lower limit. To change from "SCAN+"
to "SCAN-" or vice versa, press SCAN.
NOTE: When programmed, the upper and lower scan limits will also act
the upper and lower operating limits of the radio. The radio cannot now
be programmed to operate above or below the scan limits.
Memory Scanning
The DX 2527 has 10 non-volatile (i.e., memory resident)
memory locations that can be programmed with any available
frequency within the operating band of the radio. The scan
function of the unit can be programmed to scan these memory
channels. The radio will then scan only those memory channels
that have been pre-programmed.
The first step in utilizing the memory scan function is to
program the desired frequency into the radio memory. This can
be accomplished by performing the following steps:
1. With the radio operating in the manual mode, press the
PRG (Program) button.
- 16 -
2. Press the MEM button. "PRG" should be display in the
lower right-hand corner of the LCD display window. In the
upper left portion of the display, "MEM" should be
displayed. Directly below MEM, a number between 0 and
9 will be displayed. This number represents the memory
location currently being displayed. Pressing the MEM key
will increase the memory counter to the next memory
location and the contents of that memory location will be
displayed.
3. Using the SHF button and UP and DOWN arrows, enter
the frequency to be stored in the memory location
displayed. After the desired frequency has been entered,
press ENT.
4. Repeat steps 2 and 3 for all of the memory locations to be
programmed.
5. After the desired memory locations have been programmed
with frequencies, return the unit to the manual mode of
operation by pressing the MAN button.
6. To initiate memory scanning, press MEM and then press
SCAN. As previously discussed, the display will show
"SCAN+" or "SCAN-" to indicate whether the radio is
scanning from the lowest to the highest memory location or
vice versa. To return the radio to normal (non-scanning)
operation, press the MAN button.
Offset Frequency Operation
The DX 2527 has an offset or split frequency feature that will
permits the radio to be operated in a half-duplex mode. This
will allows the user to talk on FM repeaters operating in the 10
meter band. This split frequency function offsets the
- 17 -