dbx 30 Series Manual de operação - Página 7

Procurar online ou descarregar pdf Manual de operação para Stereo Equalizer dbx 30 Series. dbx 30 Series 20 páginas. Graphic equalizers

Imprimir página
dbx 30 Series Manual de operação
30 SERIES GRAPHIC EQs
P
S
:
OWER
WITCH
LED.
P
LED:
Lights to indicate that the equalizer is turned on.
OWER
EQ I
/O
:
This switch removes the equalizer's input gain and individual slider controls from the signal
N
UT
path. This does not, however, affect the HI CUT and LOW CUT filters. The entire equalizer is
enabled when the switch is in.
B
/C
R
OOST
UT
ANGE
equalizer will use, either ±6dB or ±12dB (3031C: -10dB or -20dB)
H
B
EADROOM
AR
3dB below clipping and indicates overload at the post-input gain, pre-EQ and post-EQ points in the
signal path.. Overload at the input amplifier is indicated by the entire LED bar graph getting brighter
when the signal is 3dB below clipping.
I
G
C
NPUT
AIN
ONTROL
+15dB of gain. Its effect is indicated on the HEADROOM BAR GRAPH.
F
B
REQUENCY
AND
noted frequency by ±6 dB or ±12dB depending upon the position of the BOOST/CUT RANGE
SWITCH (3031C is cut only: -10db or -20db). When all of the sliders are in the center detented posi-
tion, the output of the equalizer is flat (3031C: sliders placed at top position is flat). The frequency
band centers of the 3215 are marked at 2/3rds of an octave ISO spacings. The frequency band cen-
ters of the 3031,3031C, and 3231 are marked at 1/3rd of an octave ISO spacing.
L
C
F
O
UT
REQUENCY
frequency of the LO-CUT filter. It is variable from 25 Hz to 200 Hz. The roll-off of this filter is 12dB
per octave. The LO CUT IN/OUT switch to the left of this control inserts or removes the LO CUT filter
from the signal path. When the LO CUT IN/OUT switch is pushed IN, the LO CUT filter is IN the cir-
cuit.
H
C
I
/O
S
I
UT
N
UT
the HI-CUT IN/OUT switch is pushed IN, the HI-CUT filter is IN in the circuit.
Turns the equalizer's power ON or OFF. Power ON is indicated by the lighted power
S
S
ELECTION
WITCH
G
:
The eight LEDÕs indicate peak levels within the equalizer. The top LED is
RAPH
:
This control sets the signal level to the equalizer. It is capable of -12dB to
S
C
:
LIDER
ONTROL
C
L
ONTROL AND
:
This switch inserts or removes the HI-CUT filter from the signal path. When
WITCH
:
The switch selects which of the two boost/cut ranges the
Each one of these slider potentiometers will boost or cut its
C
I
/O
S
O
UT
N
UT
WITCH
OPERATING CONTROLS
:
This control varies the cutoff