909 P3059 Manual de instruções - Página 9
Procurar online ou descarregar pdf Manual de instruções para Serra 909 P3059. 909 P3059 16 páginas.
Imprimir páginaAdjusting the cutting angle
1. To change the cutting angle loosen the 2 hex screws
securing the fence using the 8mm hex key supplied
(Fig. G).
G
2. Move the rear fence to the desired angle using the scale
as a guide (Fig. H).
3. Tighten the 2 hex bolts to secure the fence in position.
CAUTION.
Only perform mitre cuts when the fence is set at
the most forward position.
Note.
For accurate cuts, test the cutting angle on some
similar scrap material and adjust the angle to suit your
requirements. The scale is only a guide.
Adjusting the fence
1. The original spacing between the vise and the fence is
6 1/2" (165mm).
2. When cutting wider materials the rear fence will need to
be adjusted to the rear positions. When cutting narrow
workpieces the fence should be positioned in the most
forward position.
3. To adjust the fence loosen
and remove the two hex
bolts securing the fence
using the 8mm hex key
supplied (Fig. I).
4. Move the fence backwards or forwards to one of the
5. Tighten the 2 hex bolts to secure the fence in position.
CAUTION.
when using the two wider interval settings.
H
Note.
placed in a new position, ensure
the flat washer is under the head
of the Hex bolt and sitting on top
of the indicator plate. The large
star washer should be placed
between the indicator plate and
the fence quadrant (Fig. J).
Turning on and off
1. Plug the cordset into the mains socket.
2. Push the lock-off button and
3. To stop the tool release the
4. When you release the trigger
WARNING.
for a short period of time after the trigger switch has
been released.
I
9
other two fixing positions .
Narrow workpieces may not be secured safely
When the rear fence is
pull the trigger to start the
tool (Fig. K).
trigger switch.
switch, the machine turns
off and the lock-off button
re-engages to prevent
accidental operation.
The cutting disc will continue to run down
J
K