Hifonics Zeus ZRX600.4 Manual do utilizador - Página 5
Procurar online ou descarregar pdf Manual do utilizador para Amplificador para automóvel Hifonics Zeus ZRX600.4. Hifonics Zeus ZRX600.4 14 páginas. Zeus zrx series
Também para Hifonics Zeus ZRX600.4: Manual do utilizador (14 páginas)
Imprimir página
- 1. Table of Contents
- 2. General Installation Procedure
- 3. Amplifier Feature Descriptions
- 4. Zrx500.2 / Zrx1200.2 2-Channel Amplifier Applications
- 5. Full Range Stereo / Mono
- 6. Zrx600.4 / Zrx1000.4 / Zrx2000.4 4-Channel Amplifier Applications
- 7. Zrx600.4 / Zrx1000.4 / Zrx2000.4 4-Channel Amplifier Applications
- 8. Zrx1000.1D / Zrx1500.1D / Zrx2000.1D / Zrx3000.1D 1-Channel Amplifier Applications
- 9. Features and Specifications
- 10. Setting up Systems after Installation for Best Performance
- 11. Troubleshooting and Diagnostics
- 12. Product Warranty
- 13. Oem Integration Accessories
ZRX500.2 / ZRX1200.2 2-CHANNEL AMPLIFIER APPLICATIONS
FULL RANGE STEREO
This is the most basic application for the ZRX Series 2 channel amplifiers.
1. Interconnect cable checklist:
Connect the LINE INPUTS to the Radio/CD with good quality RCA cables.
2. Crossover Switch:
The X-OVER switch must be in the FULL position.
3. Crossover frequency control checklist:
N/A for full range operation.
FULL RANGE
STEREO LINE INPUT
MONO
This application illustrates the basic mono bridging method for all Hifonics
amplifiers.
Interconnect cable checklist:
A MONO signal source is required, such as would be available from the mono
sub bass output of an active crossover, whether stand alone, or built into a head
unit or equalizer. Important: Do not be tempted to connect the hot, or positive
outputs, from any source together to obtain a mono signal, as this could very
well damage the output stage of that source.
It is necessary to feed the SAME signal to both left and right inputs via a Y-
adapter RCA cable. Connect the mono speaker positive terminal to the LEFT +,
and its negative terminal to RIGHT -.
FULL RANGE
MONO LINE INPUT
VIA Y-ADAPTER
FROM MONO SOURCE
3
4. Line Level:
Refer to the section "Setting up systems after installation for best performance"
NOTE: Minimum final loudspeaker impedances:
4 & 2 Ohms stereo mode or 4-Ohms mono mode
This amplifier will not do 1 Ohm stereo or 2/1 Ohm mono operation.
ZEUS
Switch setting checklist:
- The AMPLIFIER X-OVER switch should be in the LP/BP position.
Crossover frequency control setting checklist:
LPF: 11 o'clock
Minimum final loudspeaker impedance:
- 4 ohm mono.
ZEUS
FULL RANGE
SPEAKERS
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND
MONO SPEAKER
or SUBWOOFER
TO BATTERY +12v
VIA FUSE
REMOTE TURN-ON
CHASSIS GROUND