909 H144L1 Manual de instruções - Página 12

Procurar online ou descarregar pdf Manual de instruções para Perfurar 909 H144L1. 909 H144L1 17 páginas. 14.4v sds plus pneumatic action variable speed hammer drill driver

Imprimir página

Battery charging

IMPORTANT.

Before attempting to charge the battery,

check the plug pack, the charger base adaptor and the

battery to ensure the charging equipment matches the

battery supplied. The components are all labelled with

component numbers.

IMPORTANT.

The battery will be fully charged after

approximately 3–5 hours: remove it from the charger after

this time. Do not leave a battery charging for longer than

24 hours.

Note.

The battery pack will not charge if the battery cells are

hot. If the pack has been directly taken from the drill after

heavy or constant use, the cells will be hot.

Allow the cells to cool before fitting to the charger base

adaptor.

When the base adaptor is fitted to the battery pack and

turned on, if both red and green lights are on, the battery

is not charging. Either the battery is fully charged, or the

battery is too hot.

DO NOT

force cool the pack.

1. As described in the previous

section, "Fitting and removing

the battery pack", fit the

charger base adaptor on to the

battery fully. The charger base

adaptor is retained on the

battery pack runners. It does

not "click" into place.

Note:

If the battery pack is incorrectly orientated the battery

will not fully enter the base as depicted.

2. Plug the plug pack into the

charger base adaptor and plug

in the plug pack and switch on

at the power supply. A small

red LED light on the plug pack

will glow when the power

is turned on. The red LED

indicator light located on the

charger base adaptor will indicate that power is available

to charge the battery.

The green light on the charger base adaptor will NOT

illuminate during the charging process, so if the green

light is on the battery is not charging.

3. The charging time is approx 3–5 hours. The red LED

on the charger base adaptor will remain on during the

entire process. The green light will illuminate when the

charge process is complete and the battery is no longer

charging.

4. Turn off the charger power supply from the mains and

then remove the battery pack from the charger base.

Both the battery pack and the charger may become warm

to touch. This is also normal and not an issue of concern.

Both the battery pack and charger are fitted with thermal

safety devices and they will shut down if the temperatures

become too high.

To obtain the best life for the battery

Never allow the drill to come to a complete stand still

before recharging. The battery should be placed on charge

whenever the battery is noticeably running down or the

drill no longer performs a task it previously performed. For

storage, charge between 50 and 75%. Avoid allowing lose

items like screws or nails etc. to be stored with battery

packs as these or similar items can short battery packs

and cause a fire or explosion.

Always unplug the charger when not in use and store in

a dry secure place.