Galaxy LEC Instruções de instalação e de utilização - Página 2
Procurar online ou descarregar pdf Instruções de instalação e de utilização para Equipamento elétrico Galaxy LEC. Galaxy LEC 4 páginas. Electronic ballast
Imprimir páginaSAFETY FIRST!
D O NOT alter or modify this unit in any way. It may cause bodily injury or
death as this is a high power electrical device.
DO NOT submerse in water or splash water on the unit.
DO NOT plug or unplug the lamp cord while the ballast is energized.
These high performance, low frequency square wave electronic ballasts are
extremely efficient. They have a high power factor and high luminous efficacy.
It's stable performance creates constant power output even when power fluctuates
(power surge). Short circuit protection technology prevents damage to the lamp
and other ballasts connected to the same circuit.
1. INSTALLATION PROCEDURE
D O NOT alter or modify the electronic ballast in any way.
Not only may it damage the unit, it will void the warranty.
L amp power rating must match electronic ballast power rating.
CONNECT APPROPRIATE
AC POWER PLUG HERE
906270 includes 120V cord
(purchase 208 or 240V
separately) .
906272 includes hardwired
277V cord
The 906270 Galaxy
exclusive Smart Volt
120, 208 or 240 volt power by simply plugging in the appropriate power cord.
The 906272 Galaxy
available. There are no further modifications necessary. The Galaxy
Technology 315 Watt 120V - 240V Ballast comes with a 120 volt power cord. If you
wish to run this ballast on 208 or 240 volt, you must purchase the 240 volt power
cord separately (part #903082 six foot or #903084 twenty foot).
2. SPECIFICATIONS
9 06270 is 120, 208 or 240 Volt,
906272 is 277V only
P ower source frequency: 50/60Hz
P ower Factor (cosø): > 0.98
3. NOTES
T he Galaxy LEC Electronic Ballast is designed to operate 315 watt ceramic
metal halide lamps.
T his unit offers short-circuit and power fluctuation.
240V WIRING - VERY IMPORTANT! All digital ballasts may malfunction if the
240V circuit has a neutral. The input for the ballast is 2 HOT WIRES and 1 GROUND
WIRE. If you are using a light controller ONLY bring a ground wire and two hot leads
from your electrical panels.
HOT RESTRIKE - It is VERY IMPORTANT that the lamp is given adequate time
to cool down before it is reignited. You should allow a hot lamp to cool for 20-30
minutes before you try to restrike it. Hot restrikes cause permanent lamp failure and
lumen output degradation. Additionally, the lamp should never be turned off before
the lamp reaches full intensity.
Galaxy
Technology Ballast
LEC
Brand Technology 315 Watt 120V - 240V Ballast offers our
®
®
feature – it is a "smart" ballast that will operate on either
®
LEC
Brand Technology 315 Watt 277V only ballasts are also
®
®
LEC
Brand
®
®
A mbient Temp: -4˚F to 104˚F
Crest Factor: < 1.6
Acoustic Resonance: none
T otal Harmonic Distortion:
(THD): < 15%
OUTPUT TO HPS/MH LAMP
Connect "Sun System
lamp cord with male plug to
female receptacle on ballast
LEC
Brand
®
®
"
®