dbx 902 Manual - Página 2

Procurar online ou descarregar pdf Manual para Hardware informático dbx 902. dbx 902 8 páginas.

Imprimir página

C A U T I O N

R I S K O F E L E C T R I C S H O C K

D O N O T O P E N

A T T E N T I O N :

R I S Q U E D E C H O C E L E C T R I Q U E - N E P A S O U V R I R

W A R N I N G :

T O R E D U C E T H E R I S K O F F I R E O R E L E C T R I C

S H O C K D O N O T E X P O S E T H I S E Q U I P M E N T T O R A I N O R M O I S T U R E

The symbols shown above are internationally accepted symbols that warn of

potential hazards with electrical products. The lightning flash with arrowpoint in

an equilateral triangle means that there are dangerous voltages present within

the unit. The exclamation point in an equilateral triangle indicates that it is nec-

essary for the user to refer to the ownerÕs manual.

These symbols warn that there are no user serviceable parts inside the unit.

Do not open the unit. Do not attempt to service the unit yourself. Refer all ser-

vicing to qualified personnel. Opening the chassis for any reason will void the

manufacturerÕs warranty. Do not get the unit wet. If liquid is spilled on the unit,

shut it off immediately and take it to a dealer for service. Disconnect the unit

during storms to prevent damage.

U.K. MAINS PLUG WARNING

A moulded mains plug that has been cut off from the cord is unsafe. Discard the

mains plug at a suitable disposal facility. NEVER UNDER ANY CIRCUM-

STANCES SHOULD YOU INSERT A DAMAGED OR CUT MAINS PLUG INTO

A 13 AMP POWER SOCKET. Do not use the mains plug without the fuse cover

in place. Replacement fuse covers can be obtained from your local retailer.

Replacement fuses are 13 amps and MUST be ASTA approved to BS1362.

SAFETY INSTRUCTIONS

NOTICE FOR CUSTOMERS IF YOUR UNIT IS EQUIPPED WITH A POWER

CORD.

WARNING: THIS APPLIANCE MUST BE EARTHED.

The cores in the mains lead are coloured in accordance with the following code:

GREEN and YELLOW - Earth

As colours of the cores in the mains lead of this appliance may not correspond

with the coloured markings identifying the terminals in your plug, proceed as fol-

lows:

¥ The core which is coloured green and yellow must be connected to the

terminal in the plug marked with the letter E, or with the earth symbol, or

coloured green, or green and yellow.

¥ The core which is coloured blue must be connected to the terminal

marked N or coloured black.

¥ The core which is coloured brown must be connected to the terminal

marked L or coloured red.

This equipment may require the use of a different line cord, attachment plug, or

both, depending on the available power source at installation. If the attachment

plug needs to be changed, refer servicing to qualified service personnel who

should refer to the table below. The green/yellow wire shall be connected

directly to the unit's chassis.

CONDUCTOR

LIVE

NEUTRAL

EARTH GND

WARNING: If the ground is defeated, certain fault conditions in the unit or in the

system to which it is connected can result in full line voltage between chassis

and earth ground. Severe injury or death can then result if the chassis and

earth ground are touched simultaneously.

BLUE - Neutral

BROWN - Live

WIRE COLOR

Normal

Alt

BROWN

BLACK

BLUE

WHITE

GREEN/YEL

GREEN

WARNING

FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:

WATER AND MOISTURE: Appliance should not be used near water (e.g. near a bath-

tub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool,

etc). Care should be taken so that objects do not fall and liquids are not spilled into

the enclosure through openings.

POWER SOURCES: The appliance should be connected to a power supply only of

the type described in the operating instructions or as marked on the appliance.

GROUNDING OR POLARIZATION: Precautions should be taken so that the ground-

ing or polarization means of an appliance is not defeated.

POWER CORD PROTECTION: Power supply cords should be routed so that they are

not likely to be walked on or pinched by items placed upon or against them, paying

particular attention to cords at plugs, convenience receptacles, and the point where

they exit from the appliance.

SERVICING: To reduce the risk of fire or electric shock, the user should not attempt to

service the appliance beyond that described in the operating instructions. All other

servicing should be referred to qualified service personnel.

FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE:

Replace fuse with same type and rating only.

ELECTROMAGNETIC COMPATIBILITY

This unit conforms to the Product Specifications noted on the Declaration of

Conformity. Operation is subject to the following two conditions:

¥ this device may not cause harmful interference, and

¥ this device must accept any interference received, including interference

that may cause undesired operation.

Operation of this unit within significant electromagnetic fields should be avoided.

¥ use only shielded interconnecting cables.

DECLARATION OF CONFORMITY

ManufacturerÕs Name:

ManufacturerÕs Address:

declares that the product

dbx 902

conforms to the following Product Specifications:

EMC:

Supplementary Information:

The products herewith comply with the requirements of the EMC

Directive 89/336/EEC (1989), as amended by the CE marking direc-

tive 93/68/EEC (1993).

dbx Professional Products

President

8760 S. Sandy Parkway

Sandy, Utah 84070, USA

April 30, 1996

European Contact: Your Local dbx Sales and Service Office or

International Sales Office

68 Sheila Lane

Valparaiso, Indiana

46383, USA

Tel: (219) 462-0938

Fax: (219) 462-4596

dbx Professional Products

8760 S. Sandy Parkway

Sandy, Utah 84070, USA

EN 55013 (1990)

EN 55020 (1991)