909 T12 Series Manual - Página 3

Procurar online ou descarregar pdf Manual para Perfurar 909 T12 Series. 909 T12 Series 17 páginas.

Imprimir página

OPERATING INSTRUCTIONS

• Do not allow familiarity with tools to make you careless.

Remember that a careless fraction of a second is enough

to cause serve injury.

• Before attempting to use this cordless drill, become

familiar with all of its operating features and safety

requirements.

• To reduce the risk of serious personal injury, turn

tool off and disconnect battery pack before making

any adjustments or removing/installing attachments or

accessories.

CHARGING PROCEDURE

• Connect the plug cable to the charger, and then plug into an

appropriate outlet before inserting

battery pack. After approx 5 sec, all three

charging lights will be on for two seconds

and then off, indicating power is available

(fig. A)

at the charger.

• Insert the battery pack into the charger,

making sure the pack is fully seated in the

charger. The charging process has now

(fig. B)

begun.

During the charging process, the charging

lights will indicate the charging status as

below:

- Less than 30% charged, all three charging

lights will blink in sequence.

- Less than 60% charged, one light will

stay on, while the other two lights will

blink in sequence.

- Over 60% charged, two lights will stay on, while the remaining

light will blink continuously.

- Fully charged, all three lights will remain on continuously.

• As a guide, the charging process will be last approximate 30 min

for a 2 Ah Battery Pack and approx 60 min for a 4Ah battery pack,

and will be displayed by permanent lighting of all three charging

lights.

Touch_IM_ED8.indd 3

CHARGER DIAGNOSTICS

The charger is designed to detect certain problems

that can arise with battery packs.

• When the charger detects a battery pack that is overheated, all

three charging light will blink at the same time. Please remove the

battery and allow it to cool down for 15 – 30 minutes and re-insert.

• When the charger detects malfunction in the battery or the charger,

two charging lights will blink at the same time. Please remove

the battery and allow to cool down for 15-30 minutes. Then re-

insert the battery pack into the charger, if two charging lights still

flashes, the battery or charger may require service.

NOTE: Charging times maybe longer depending on the

surrounding temperature and battery conditions.

Fitting and removing the battery pack

to the drill

• To install the battery pack to the tool, align

the raised portion of the battery pack with

the grooves on the bottom of the drill, and

slide it firmly into the handle until you

hear the lock snap into place.

• To remove the battery pack from the tool,

press the battery pack release button and

slide the battery pack completely out of

tool handle.

Battery charging

CAUTION!

• Before attempting to charge the battery, check the

charger and the battery to ensure the charging equipment

matches the battery supplied. The components are all

labeled with component numbers.

• The rechargeable battery is not fully charged on leaving the

factory. Charge the rechargeable battery before first use.

• Recharge discharged batteries as soon as possible after

use or battery life may be greatly diminished. For longest

battery life, do not discharge batteries fully.

• The working temperature of the charger is 0 degree to

45 degrees (32 degree f to 115 degree f).

(fig. C)

22/10/13 4:39:52 PM