DYNAPAR Danaher Controls A103-004 Manual técnico - Página 3

Procurar online ou descarregar pdf Manual técnico para Instrumentos de medição DYNAPAR Danaher Controls A103-004. DYNAPAR Danaher Controls A103-004 4 páginas. Programmable rate meter

Imprimir página

SETUP

•

INSTALLATION

Battery Slots

Battery Installation - The unit is shipped with one battery, which is not

installed. Remove the battery cover by pushing inward and down. Install

the battery in either of the two slots. The unit runs on a single battery,

and the second slot is provided to allow for installing a new battery before

removing the old one, retaining count total and program data. The unit

can also be run on two batteries to extend the battery life to 10 years.

Once the battery is in place the unit will go into a self test mode, and all

the segments on the LCD display will be illuminated. The self test mode

is exited by depressing the Next key, which will then display the model

number (4). Depress the Next key again to ready the unit for operation.

Front Panel Installation . Place the unit in the panel through the

33mm x 68mm cutout. Slide the included gasket over the rear of the

unit, then slide the panel mount bracket into place so that the 4 tabs

catch in the groves on the top and the bottom of the unit (the bracket

should be oriented so that the tabs are on the side nearest the panel).

Use the provided panel mount screws to tighten the bracket until there

is a secure seal against the gasket.

PROGRAMMING

, nnni

I.U U U

2 .

nnni

I.U U U

1:1.

Programming parameters can be accessed, when the Program Enable input is active, by

pressing the Down key. To edit a parameter use the Down key to scroll until the

desired parameter appears on the screen. Pressing the Next key will cause the leftmost

digit of that value to begin to flash. Use the Next and Down keys in combination to

choose individual digits and change their value.

Rate Calibrator Decimal Point: Sets the decimal pOSition to be used with the Rate Input Calibrator in

a range from X.XXX to XXXX.

Rate Input Calibrator: Multiplies the input j)'equency by this value and displays the results as the rate

value. In combination with the Rate Decimal Point Parameter the calibrator value can be set in a range

[rom 0.001 to 9999.

Rate Display Decimal Point: Sets the decimal position to be used for the rate display in a range from

Off to 0.000. This parameter can also be used to set a dummy zero L ___ 0) which enables the rate

display to have 5 digits with the LSD always being O. The Next key is used to scroll through the choices.