Autonics FS4A Manual de início rápido - Página 5
Procurar online ou descarregar pdf Manual de início rápido para Temporizador Autonics FS4A. Autonics FS4A 5 páginas. Din w48xh48mm 8 pin plug counter
Imprimir página
b
2N CASE OF CHANGING THE INPUT MODE AFTER SUPPLYING
THE POWER PLEASE TAKE A EXTERNAL RESET OR MANUAL
RESET
b
2T IS RESET PERFECTLY WHEN THE RESET SIGNAL IS APPLIED
DURING
REGARDLESS OF THE CONTACT INPUT
SOLID STATE INPUT
2N CASE OF A CONTACT RESET IT IS RESET PERFECTLY IF
THE 65 TIME OF RESET SIGNAL IS APPLIED DURING MIN
MS EVEN THOUGH CHATTERING IS OCCURRED
2T CAN BE INPUT THE SIGNAL OF ,7
MS FROM CLOSING TIME OF RESET SIGNAL
:HE POWER
<-, WHICH IS PROVIDED TO SENSOR IS
BUILT IN IT 7LEASE USE IT UNDER 4AX
7LEASE MAKE DUTY RATIO 65 6//
4IN SIGNAL WIDTH
:HIS IS A RESPONSE SPEED PER
RATIO 65 6// OF INPUT SIGNAL IS
RATIO IS NOT
THE WIDTH BETWEEN 65 AND 6//
SHOULD BE OVER MIN SIGNAL WIDTH AND THE RESPONSE
SPEED IS GETTING SLOWER AGAINST INPUT SIGNAL
2F EITHER 65 OR 6// SIGNAL IS SHORTER THAN MINIMUM
SIGNAL WIDTH THIS PRODUCT MAY NOT RESPOND
,7 AFTER MIN
M*-,
CPS 4IN
SEC
CPS 4IN
MS
KCPS 4IN
MS
KCPS 4IN
MS
SEC WHEN THE DUTY
2F THE DUTY
.RROR SIGNAL
.RROR DESCRIPTION
@ERO SETTING STATUS
^=HEN .RROR IS DISPLAYED THE OUTPUT CONTINUES 6// STATE
^:HERE IS NO .RROR FUNCTION IN INDICATOR
=HILE PUSHING THE 3OCK PART WITH WITH DRIVER TO THE
FRONT PUSH THE TERMINAL BLOCK
=IDEN THE LOCK DEVICE TOWARD OUTSIDE PUSH THE PLUG
TO THE FRONT
-ETACH THE CASE
^7LEASE BE CAREFUL TO USE WITH TOOLS IT MAY CAUSE INJURY
:HE INNER CIRCUIT VOLTAGE STARTS TO RISE UP FOR THE FIRST
MS AFTER POWER ON THE INPUT MAY NOT WORK AT THIS
TIME *ND ALSO THE INNER CIRCUIT VOLTAGE DROPS DOWN
FOR THE LAST
MS AFTER POWER OFF THE INPUT MAY NOT
WORK AT THIS TIME
8ETURNING METHOD
,HANGE THE SETTING VALUE
TO NON ZERO STATUS