DC 1100.1 Manual do Proprietário - Página 4

Procurar online ou descarregar pdf Manual do Proprietário para Amplificador DC 1100.1. DC 1100.1 8 páginas.

4-2. 4channels control
RCA JACK INPUT
Low Level Rca Input will accept the signal from the output of
head units. Plug in Rca jack cables from the head unit.
GAIN CONTROL ( 6V ~ 0.2V )
The gain control adjusts the gain level. so that this is used to
match the signal level of di erent headunits.
4-3. Power, Ground & Remote connection.
+12V SOURCE
GND ( GROUND )
Locate a secure grounding connection as close to ampli er as possible.
Make sure the location is clean and provides a direct electrical connection to the frame of the vehicle.
The ground needs to have as low of a resistance as possible.
Connect one end of a short piece of the same size cable as the power cable to the grounding point or to one
of your ba eries or ba ery bank.
Run the other end of 4 ( 0 ) gauge cable to the mounting location of the ampli ers for connection
to the ampli ers ground terminals and connect the ground cable to the GND ( ground terminal ).
Remote Turn on
Working Ba ery voltage
9V to 16volts
HIGH PASS FILTER ( 50Hz ~ 500Hz )
Linkwitz-Riley high pass crossover ensuring that only
the highest frequencies are reproduced by the ampli er
LOW PASS FILTER ( 50Hz ~ 500Hz )
Linkwitz-Riley low pass crossover ensuring that only
the lowest frequencies are reproduced by the ampli er.
X-OVER SLECTOR SWITCH ( HPF/FULL/LPF )
Selected x-over is in e ective.
Fuse
BATTERY
3
FUSE RATES ;
1100.1 : 100A
2100.1 : 200A
300.4 : 30A
1000.4 : 90A