Galaxy Equipment 177IMBL7 Manual do utilizador - Página 4
Procurar online ou descarregar pdf Manual do utilizador para Liquidificador Galaxy Equipment 177IMBL7. Galaxy Equipment 177IMBL7 7 páginas. Immersion blenders
Imprimir páginaCleaning
The equipment must be clean at all stages of production. It is vital to clean all parts of the immersion blender between
each job using a detergent or disinfectant.
WARNING:
Always unplug your appliance before cleaning it.
WARNING:
Check that your detergent is suitable for cleaning plastic parts.
Some washing agents are too alkaline (e.g. high levels of caustic soda
or ammonia) and totally incompatible with certain types of plastic,
causing them to deteriorate rapidly.
WARNING:
NEVER immerse the motor unit or its handle in water.
NOTE: After completion of preparation, clean immediately to prevent food from sticking to surfaces.
NOTE: After using the immersion blender in a hot preparation, cool the bottom of the foot in cold water
before dismantling.
RINSING
1. Place the foot and bell into a suitable container with water and switch on for a few seconds to rinse.
CLEANING
1. Unplug the immersion blender.
2. Detach the shaft from the motor unit and set aside.
3. Using a damp sponge or cloth, wipe the exterior of the motor unit.
Be careful to avoid getting moisture inside the air vent holes on the side.
4. Dry motor unit with a clean towel.
5. Rinse the shaft under the tap.
6. Remove the bell from the shaft.
7. Then remove the blades from the bell. Be careful to avoid damaging water-proof seals.
8. Use a detergent/disinfectant (diluted per manufacturer's instructions) to gently scrub each component.
9. Rinse all parts.
10. Allow to dry completely before reassembly.
Maintenance
•
Before every use inspect the power cord to make sure it is undamaged.
•
Routinely check the state of all watertight membranes and seals.
Even the slightest cracks will allow liquid to seep in.
•
Routinely check the state of the blender housing. This should not show any signs of cracking which would
allow access to the live components within.
•
Routinely check the condition of the blade. If performance begins to decline, the blade, as well as the washer and
watertight seals around it, should be replaced. Be careful when inspecting the blade as it is very sharp.
4
Attack tough grease, oil, and carbon with this ready to use decarbonizer
and degreaser. Its unique formula is designed to clean ovens, grills,
hoods and a wide variety of other surfaces.
User Manual