IHC suspension GM 1500 Manual de instruções - Página 2
Procurar online ou descarregar pdf Manual de instruções para Acessórios para automóveis IHC suspension GM 1500. IHC suspension GM 1500 17 páginas. 5” rear drop- reverse hanger
Imprimir página
READ INSTRUCTIONS THOROUGHLY AND COMPLETELY BEFORE BEGINNING INSTALLATION.
INSTALLATION BY A CERTIFIED PROFESSIONAL TECHNICIAN IS HIGHLY RECOMMENDED.
IHC Suspension IS NOT RESPONSIBLE FOR ANY DAMAGE OR FAILURE RESULTING FROM IMPROPER INSTALLATION.
Safety Warning
MISUSE OF THIS PRODUCT COULD LEAD TO INJURY OR DEATH.
Suspension systems or components that enhance the on and off-road performance of your vehicle may cause it to handle differently
than it did from the factory. Extreme care must be used to prevent loss of control during abrupt maneuvers.
Always operate your vehicle at reduced speeds to ensure your ability to control your vehicle under all driving conditions. Failure to
drive safely may result in serious injury or death to driver and passengers.
Driver and passengers must ALWAYS wear your seat belts, avoid quick sharp turns and other sudden maneuvers. IHC Suspension
does not recommend the combined use of suspension drop spindles, drop struts, drop springs or other lowering devices.
You should never operate your vehicle under the influence of alcohol or drugs.
Constant maintenance is required to keep your vehicle safe. Thoroughly inspect your vehicle before and after every drag race/race
use.
It is the responsibility of the retailer and/or the installer to review all state and local laws, with the end user of this product, related
to bumper height laws and the lowering of their vehicle before the purchase and installation of any IHC Suspension products.
It is the responsibility of the driver/s to check their surrounding area for obstructions, people, and animals before moving the
vehicle.
All lowered vehicles may have increased blind spots; damage, injury and/or death can occur if these instructions are not followed.
Installation Warning
All steps and procedures described in these instructions were performed while the vehicle was properly supported on a two-post
vehicle lift with safety jacks.
Use caution during all disassembly and assembly steps to ensure suspension components are not over extended causing damage to
any vehicle components and parts included in this kit.
Included instructions are guidelines only for recommended procedures and are not meant to be definitive. Installer is responsible to
insure a safe and controllable vehicle after performing modifications.
IHC Suspension recommends the use of an OE Service Manual for model/year of vehicle when disassembly and assembly of factory
and related components. Unless otherwise specified, tighten all bolts and fasteners to standard torque specifications listed within
the OE Service Manual.
Suspension components that use rubber or urethane bushings should be tightened with the vehicle at normal ride height. This will
prevent premature wear or failure of the bushing and maintain ride comfort.
Larger tire and wheel combinations may increase leverage on suspension, steering, and related components. Due to payload options
and initial ride height variances, the amount of drop is a base figure. Final ride height dimensions may vary in accordance with
original vehicle ride height. Always measure the vehicle ride height prior to beginning installation.