iHealth BP3 Manual de operação - Página 8
Procurar online ou descarregar pdf Manual de operação para Monitor de tensão arterial iHealth BP3. iHealth BP3 11 páginas. Fully automatic arm cuff electronic blood pressure dock
Também para iHealth BP3: Manual do utilizador (12 páginas), Manual de início rápido (2 páginas)
Imprimir página
4.CONNECTING THE CUFF TO BP3
Insert the cuff tubing connector into the air port in
the left side of the Dock. Make sure that the
connector is completely inserted to avoid air
leakage during blood pressure measurements.
5. APPLYING THE CUFF
1) Pulling the cuff end through the metal loop (the cuff is packaged like this already),
turn it outward (away from your body) and tighten it and close the Velcro fastener.
2) Place the cuff around a bare arm 1/2"(1-2cm)
above the elbow joint.
3) While seated, place palm upside in front of
you on a flat surface such as a desk or table.
Position the air tube in the middle of your arm in
line with your middle finger.
4) The cuff should fit comfortably, yet snugly
around your arm. You should be able to insert
one finger between your arm and the cuff.
Note: 1. Please refer to the cuff circumference range in "SPECIFICATIONS" to
make sure that the appropriate cuff is used.
2. Measure on the same arm each time.
3. Do not move your arm, body, or the Dock and do not move the rubber tube
during measurement.
4. Stay still, calm for 5 minutes before blood pressure measurement.
5. Please keep the cuff clean. If the cuff becomes dirty, remove it from the Dock
and clean it by hand in a mild detergent, then rinse it thoroughly in cold water
and air dry. Never dry the cuff in clothes dryer and never iron it. Cleaning the
cuff after every 200 times is recommended.
6. BODY POSTURE DURING MEASUREMENT
7
1/2"(1-2cm)