Autonics ARD-DX16NE Manual - Página 8

Procurar online ou descarregar pdf Manual para Sistemas de E/S Autonics ARD-DX16NE. Autonics ARD-DX16NE 8 páginas. Devicenet digital remote i/o
Também para Autonics ARD-DX16NE: Manual (8 páginas)

Imprimir página

ARD-D Series

Setup and Installation

Mounting on DIN rail

① Pull Rail Locks (standard terminal block type: 3EA, sensor connector type: 2EA)

on the rear part of unit.

② Place the unit on DIN rail to be mounted.

③ Press Rail Locks to fix the unit tightly.

Connection of basic unit and expansion units

(standard terminal block type)

① Turn OFF the power of a Basic unit.

② Place an expansion unit to be installed next to the basic unit.

③ Connect the cable of expansion unit to the connector of a basic unit.

④ Install a connected expansion units as the right figures.

⑤ Supply the power to a Basic unit.

(Re-supply the power of a basic unit and it recognizes expansion units.)

Connection of basic unit and expansion units

(sensor connector type)

① Turn OFF the power of the basic unit.

② Remove a cover of connector for extension with nippers, etc.

③ Connect connector input part of an expansion unit and connector output

part of a basic unit with a connector which is enclosed with an expansion unit box.

④ Install a connected expansion units as the right figure.

⑤ Supply the power to the Basic unit.

(Re-supply the power of a basic unit and it recognizes expansion units.)

Communication Distance

Baud Rate

Max. network length

125kbps

500m

250kbps

250m

500kbps

100m

Terminating Resistance

● 120Ω ● 1% of metallic film

※ Do not install terminating resistance on the unit, or it may cause network terminating problem (Impedance can be too high

or low) and trouble.

※ Connect terminating resistance on the both ends of the trunk line.

Caution During Use

Turn OFF the power before connecting or disconnecting expansion units.

Node addresses of connected units on network should not be duplicated. If you change a node address during

operation,unit status (MS) red LED fl ashes and it communicates with a previous node address.

Re-supply power and the changed node address is applied.

Communication speed which is set on master is set automatically. If you change the communication speed during

operation, network status (NS) red LED turns ON and it does not communicate.

Re-supply power and it operates normally.

Make sure to use DeviceNet standards communication cables, and taps.

It may cause communication error if non-standards products are used.

Make sure to examine disconnection or short-circuit before connecting cables.

Avoid installing the units where severe dust exists or where corrosion may occur.

This unit may be used in the following environments.

• Indoor

• Altitude: Under 2,000m

• Pollution degree 2

• Installation category II

S-12

Max. branch line length

● 1/4W

Max. extended branch line length

156m

78m

39m