DC-Digital CM-1 Procedimentos de instalação - Página 2

Procurar online ou descarregar pdf Procedimentos de instalação para Conversor de multimédia DC-Digital CM-1. DC-Digital CM-1 3 páginas.

Connect the Power:

Make sure that the CM-1 will be receiving 120 VAC @ 5 amps of clean dedicated power.

Do not connect the CM-1 to power lines that share AC Motors, Heaters, or Inductive

loads. This will cause sporadic data transmission and undesirable results in correct data

transmission and reception.

Use the provided 24VDC at 1 Amp wall transformer to power the CM-1.

Note: The use of any other wall transformer other than what is required by DC-

Digital will void warranty.

Observe:

The RED 5 volt LED will light. See Picture.....

The Data RED LED will flash every time the EZ-time Software sends data out of

the designated computer COM Port either manually or automatically. See Picture

for location of the RED Data LED.

NOTE: The GREEN LED must stay on steady and RED LED must flash to indicate

correct CM-1 operation.