DCA Z1G-FF-15 Manual de Instruções - Página 5
Procurar online ou descarregar pdf Manual de Instruções para Ferramentas DCA Z1G-FF-15. DCA Z1G-FF-15 7 páginas. Percussion hammer
Imprimir página4． ． ． ．
Oil Feeding
CAUTION: Prior to oil feeding, always disconnect the plug from the
receptacle.
Since an oil chamber is built in this
tool, it can be used for approximately
20
days
without
replenishing
lubrication oil, assuming that the tool
is used continuously 3-4 hours daily.
(Fig. 5)
Feed oil into the oil tank as
described below before using this
tool.
Just before the oil level, which
can be visible in the oil gauge
window, is decreasing lower
than 3 mm when the power tool
is held upright, feed oil without
fail. (Fig. 6)
Before feeding oil, use the
provided wrench to remove the
oil gauge. Be careful not to lose
the rubber packing attached
below the oil gauge.
After feeding oil, securely clamp
the oil gauge.
Check the oil level once a day, confirming that oil is filled.
NOTE:
As an optional accessory, the oil is sold separately. Shell Oil Co. ROTELLA
#40 (engine oil) can also be used. This oil is sold as Shell gasoline stations
most anywhere.
-7-
MAINTENANCE AND INSPECTION
CAUTION:
Always be sure that the tool is switched off and unplugged before attempting to
perform inspection or maintenance.
1． ． ． ．
Inspecting the Bit
Since use of a dull bit will degrade efficiency and cause possible motor malfunction,
sharpen or replace the bit as soon as abrasion is noted.
2． ． ． ．
Inspecting the Mounting Screws
Regularly inspect all mounting screws and ensure that they are properly tightened.
Should any of the screws be loose, retighten them immediately. Failure to do so
could result in serious hazard.
3． ． ． ．
Inspecting and Replacing Carbon Brushes
Remove and check the carbon brushes
regularly. Replace when they wear down
less than 7 mm (Fig. 7). Keep the carbon
brushes clean and free to slip in the
holders. Both carbon brushes should be
replaced at the same time. Use only
identical carbon brushes.
Loosen the screw of the cap covers,
remove the cap covers, rubber washers
and brush holder caps in order. Take out
the worn carbon brushes, insert new ones
and secure the brush holder caps, then
mount the rubber washers and cap covers
securely. (Fig. 8)
※ ※ ※ ※ To maintain product SAFETY and RELIABILITY, repairs, any other maintenance or
adjustment should be performed by authorized centers, always using original
replacement parts.
-8-