DCD 61400-000 Manual de Instruções - Página 5

Procurar online ou descarregar pdf Manual de Instruções para Equipamento industrial DCD 61400-000. DCD 61400-000 14 páginas. Lineman lasher

1. Loading the Wire Spools on the Lasher

To prepare the Lineman Lasher for lashing, the first step is to load the lashing

wire. Whether using .045" or .038" lashing wire, follow these steps.

Remove the wire spool flange by turning in clockwise rotation (left to right). To

1a)

keep spool from turning, insert finger in hole (or the end of a screw driver or

tool) on back side of well in cable opening in the drum.

Cut two wire ties. Insert coil of wire on spool so coil of wire will turn in a

1b)

counterclockwise rotation (Right to left) when pulling on wire. (Load both

sides to rotate in a conterclockwise direction). Cut and remove remaining

twowire ties. Replace flange and tighten flange as tight as possible to keep

coil of wire from turning on wire spool. (To hold wire spool from turning when

tightening flange, insert finer in the hole located on back side of wire spool

well at bottom.)

Page | 4