Autopage Car-Pro CPX-RS1 Manual do Proprietário - Página 3
Procurar online ou descarregar pdf Manual do Proprietário para Arrancador remoto Autopage Car-Pro CPX-RS1. Autopage Car-Pro CPX-RS1 4 páginas. Remote engine starter
Também para Autopage Car-Pro CPX-RS1: Manual do Proprietário (4 páginas)
Imprimir página
E. TEMPORARY STOP FEATURE:
This feature allows the vehicle to remain running after the key has been removed from the ignition. This feature is useful for
occasions when you wish to exit and lock the vehicle for short periods of time, but would like to leave the engine running
and the climate control on.
1.Before turning off the engine, Place the vehicle in "Park"; take your foot off the brake pedal; press the transmitter
button twice and the LED indicator will flash 3 times to confirm enter.
2.Turn the ignition key to the "OFF" position and remove the key. (The engine will stay running.)
3.The engine will run until the pre-programmed time has elapsed or one of the shutdown inputs is received.
F. TIMER START:
This unit can be programmed to start and run the engine every 3 hours. The engine will run for the programmed run time
and then shut down.
IMPORTANT: Timer Start should be used only in open areas. You should never start and run the vehicle in on enclosed
space as a garage or carport.
3 hours timer start: This feature is design for an extreme cold climate usage. The system will auto start the vehicle every
3 hours, to prevent extremely difficult cold start problems. A MAXIMUM OF SIX CYCLES CAN OCCUR.
ENTER:
1. Press the transmitter
lights have turned on or flashing.
2. Immediately depress the
3. Quickly press the
is now programmed to start every (3) hours.
4. Press the brake pedal to stop the vehicle running.
Exit the timer start:
Timer start can be exited manually as follows:
1. Make sure the remote start system is not operating the engine.
2. Turn the ignition "ON". The LED and parking light will flash (4) times. The horn (if installed) chirps (4) times.
Or
1. Press the transmitter
parking lights have turned on or flashing.
2. Immediately depress the
seconds.
The parking lights will flash (4) times. The horn (if installed) will chirp (4) times. The vehicle is no longer programmed to
start automatically.
G. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut down immediately:
1.
The hood is opened.
2.
The brake pedal is pressed.
3.
Move the optional remote start enable toggle switch to OFF position. (If installed)
4.
Engine is over-revved. {"Tachometer checking type" only}
5.
The pre-programmed run time (5 /10 / 20 / 30 minutes) has elapsed.
6.
Press the transmitter
7.
The vehicle refused to start running after {3} unsuccessful attempts.
8.
If your remote start does not start the vehicle after 3 attempts, please take your vehicle back to your installing
dealer for troubleshooting.
510 USA
button twice to remote start the vehicle. As soon as the vehicle is running and the parking
and
button together at the same time, within 2 seconds
button. The parking light will flash (3) times. The horn (if installed) chirps (3) times. The vehicle
button twice to remote start the vehicle. As soon as the vehicle is running and the
and
button together at the same time; then press and hold
button.
3
AUG./15/2003
button for 2