DCG VESA05 Manual do utilizador - Página 11

Procurar online ou descarregar pdf Manual do utilizador para Ventilador DCG VESA05. DCG VESA05 17 páginas. 2 in 1 heater/fan

ASSEMBLY OF BLADE AND GRILLS

1. Remove plastic sleeve of motor, grills and blade. Place rear grill (6) on the motor frontal through

motor shaft (7). Ensure the handle at the rear grill is facing up and that all guiding pegs on the

motor housing are lined up with cutouts on the rear grills.

2. Secure the rear grill into the place with the plastic nut (5). Fasten the plastic nut firmly onto the

motor housing by tightening it in a clockwise direction.

3. Install the fan blade (4) onto motor shaft (7) with the cutouts fitted. Place blade's nut (3) on the

motor shaft after the blade. Fasten it by tightening in a counter clockwise direction.

4. Fit front grill (1) with front grill ring (2a) against rear grill ring (2b) by aligning the alignment mark on

the top of the grill ring, closing them together by the hooks on front grill ring and slots on the rear

grill ring, twisting the front grill clockwise to the lock position, the snapping lock pin (20) should pop

in. Tighten the lock screw (21) to secure the snapping lock pin.

OPERATING INSTRUCTIONS

Using the control panel and remote control

This fan is equipped with 4 speeds, heater, timer,oscillation and remote control.

For your convenience, the buttons on control panel and remote control are the same.

MANUALE D'USO - USER MANUAL - VESA05

dcg16.it