Dynasplint Type II Manual de instruções de montagem - Página 2
Procurar online ou descarregar pdf Manual de instruções de montagem para Equipamento médico Dynasplint Type II. Dynasplint Type II 8 páginas. Wrist extension system
Imprimir páginaFITTING INSTRUCTIONS
IMPORTANT: Movement and rattling of spacer in the tension window is normal. This
will subside when more tension is applied to the tension screw.
STANDARD FITTING INSTRUCTIONS:
STEP 1: Completely open top-of-forearm cuff and strap. Loosen the bottom-of-
forearm cuff.
FIgurE 1.
Top-of-Forearm Cuff
STEP 2: The contour foam pad attached to the strut by a clip should be placed on
the thumb side of the hand. If necessary, remove clip with attached pad and
reverse its position with the flat pad.
STEP 3: If necessary, take the unit off and adjust the length of the struts so that the
cuff is located on the bulk of the muscle mass on the lower arm.
STEP 4: To shorten or lengthen the struts, first remove the 1/8" screw near cam. Slide
the smaller tube in or out of the larger tube to obtain correct length. Replace
and gently tighten the screws. See Figure 2.
STEP 5: To lengthen strut distal to cam, loosen side set screw and adjust length.
Tighten screw gently. See Figure 3-A.
STEP 6: Without tension on the unit, place the patient's lower arm and wrist in the
unit. Align the struts with the midlines and sides of the lower arm. Align
cams across joint axis. Fasten top-of-forearm cuff loosely, leaving strap open.
Check placement. See Figure 2.
FIgurE 2.
1
Counterforce
Strap
Velcro® Strap
Horizontal Bar
Palmar Piece
Set Screws
Cam
Horizontal Bar
Counterforce
Strap
Forearm Cuff
Strut
D-wire
Struts
Cam
OPTIOn A HAnD PIEcE*
*Hand piece is custom molded
to fit patient's hand.
OPTIOn B HAnD PAn