Emerson E2 Manual de início rápido - Página 2

Procurar online ou descarregar pdf Manual de início rápido para Instrumentos de medição Emerson E2. Emerson E2 14 páginas. Clarification of the operation of alarm annunciators
Também para Emerson E2: Manual do utilizador (17 páginas), Manual de referência rápida (2 páginas), Manual de configuração rápida (2 páginas), Manual de início rápido (8 páginas), Manual de instruções (12 páginas), Manual de início rápido (9 páginas), Manual de início rápido (14 páginas), Manual de início rápido (9 páginas), Manual de instalação e operação (20 páginas), Boletim Técnico (8 páginas)

Imprimir página
Emerson E2 Manual de início rápido
Keypad Number
1 (Enter)
2 (Navigation)
3 (Start)
4 (Stop/Reset)
5 (Escape)
STEP 1: Configuring M400 VFD Drive
Note: Do not connect the device communications to E2 controller.
1. Press right/ left arrow key and go to Pr MM.000 then press
.
Note: Pressing
2. Press
to return the drive into the No Action display.
3. Go to Pr 00.005 (Drive Config), then press
4. Set Pr 00.010 (User Security Status), then press
5. Set Pr 06.004 (Start/Stop Logic), then press
6. Set Pr 11.023 (Serial Address), then press
7. Set Pr 11.024 (Serial Mode), then press
8. Set Pr 11.020 (Serial Reset), then press
Note: The device will flash to On and returns to Off, press
9. Set Pr 12.000 (Parameter mm.000), then press
10. Press
to return the drive into the No Action display.
Note: The drive is now ready to communicate with the E2 controller and ready for test/run.
Document Part # 026-4950 Rev 0 08-OCT-2014
©2014 Emerson Climate Technologies Retail Solutions, Inc. This document may be photocopied for personal use.
Visit our website at http://www.emersonclimate.com/ for the latest technical documentation and updates.
The Enter button is used to enter parameter view or edit mode, or to accept a
parameter edit.
The Navigation keys can be used to select individual parameters or to edit parameter
values. In keypad mode, the "Up" and "Down" keys are also
used to increase or decrease the motor speed.
The Start key is used to start the drive in keypad mode.
The Stop / Reset key is used to stop and reset the drive in keypad mode. It can also be
used to reset the drive in terminal mode.
The Escape key is used to exit from the parameter edit / view mode or disregard a
parameter edit.
allows you to enter and exit parameter edit mode.
Keypad Description
. Select Reset 60Hz defs then press
. Select Preset, then press
. Select All Menus, then press
. Select 6, then press
. Select 2, then press
. Select 8 1 NP, then press
. Select On to reset communications.
.
. Select Save Parameters, then press
.
.
.
.
.
Page 2 of 14
.