Autopilot APCETHD Manual - Página 10

Procurar online ou descarregar pdf Manual para Controlador Autopilot APCETHD. Autopilot APCETHD 18 páginas.

Page 9

APCETHD

Humidity Mode – Use this button to select humidify or

dehumidify. Press Humid mode, the display will read the current

setting, either Humidify

(rH

Incr) or dehumidify

(rH

dEcr). Press

the Up and Down buttons to change the setting. Press Enter to

accept new setting.

Humid dead-band - Pressing Humidity DEAD BAND will display

the current setting. Press the Up or Down buttons to change the

setting. Press Enter to accept new setting.

CO2 ON time - To change the timer settings, press the up or

down button to change hours setting, (Left 2 digits) then press

Enter to change to the minutes (center 2 digits), use up or down

to change, then press Enter to advance to the seconds setting

(Right 2 digits). Pressing Enter a final time accepts the new

settings.

CO2 OFF time - Repeat the procedure above to change the CO2

OFF timer settings.

Temp/humidity lock - use this function to interlock (COnnEct) or

split (SPLit) humidity and temperature. Press Temp/humidity lock

button to display the setting. Press the Up and Down buttons to

change the setting. Press Enter to accept new setting.

1) Select connect (COnnEct) if using ventilating fans only for

cooling and removing humidity. The fan will turn on when the

sensor detects a rise above the setting in either the humidity or

temperature.

2) Select split (SPLit) if using a ventilating fan or AC unit as a

cooling device and a dehumidifier to remove humidity. Each

device is controlled independently. The cooling device will turn on

when the temperature rises above the setting and the

dehumidifier will turn on when the humidity rises above the

setting.