Autopot Auto8 Manuais de configuração

Procurar online ou descarregar pdf Manuais de configuração para Equipamento para relva e jardim Autopot Auto8. Autopot Auto8 2 páginas. Aquavalve

Imprimir página

Ensure the silicon is sitting parallel on

the hole below it. Hold at eye level

to check the position is correct

Ensuring that the AQUAvalve floods

and drains correctly

Making sure your AQUAvalve floods and

drains correctly is simply achieved and

only takes a few seconds.

Hold the AQUAvalve at eye level so that

you can see the silicon fitted to the top float

resting on the hole below it.

The silicon must create a tight seal when

touching the hole.

If it looks like it is not sitting parallel on the

hole below, simply lift the top float and

apply pressure to one side of the silicon,

drop the float and hold at eye level again.

Repeat the procedure if necessary.

[email protected] I www.autopot-usa.com I +(1) 702 338 0373

Simple care

guidelines

Care and maintenance

At the end of your growing season, clean

the AQUAvalve using warm soapy water.

Using an old tooth brush will help.

The AQUAvalve is easily disassembled.

The top float will slide all the way across

and the bottom float is unclipped from its

pivoting position. The circular discs fitted to

the top float can also be removed by using

pliers to grip the raised point.

At this point is it advisable to remove the

silicones to avoid them being lost.

It is also handy to have a paper clip or

pipe cleaner to hand so that you can push

it through the AQUAvalve nozzle, this will

remove any lime scale build up that may

have occurred during the growing season.

Blowing through the AQUAvalve nozzle will

also help to remove any build up. Do not

under any circumstances use a drill & drill

bit to clear the AQUAvalve nozzle.

This

will

potentially

damage

the

AQUAvalve beyond repair.

Your Auto8

Set-up Guidelines

[email protected] I www.autopot-usa.com I +(1) 702 338 0373