Dynatech YBM Instruções adicionais de manutenção e reparação - Página 5

Procurar online ou descarregar pdf Instruções adicionais de manutenção e reparação para Serra Dynatech YBM. Dynatech YBM 10 páginas. Mini masonry saw

BBM & YBM INSTRUCTIONS [May 2004]

Installing the Motor

1. With both bearings in place, push the fan side of the armature into

the cutting head casting until the large inner motor bearing "seats" in

the cutting head casting.

2. Align the plastic motor retaining plate so that the flat sections of the

plate are at the three and six o-clock positions and then push the

plastic plate into the cutting head casting until it "seats".

3. Slide the plastic motor housing over the armature just enough to

insert the two white field winding wires through the hole in the nine

o'clock position of the cutting head casting. Route the wires so that

they do not come in contact with the fan.

4. Rotate the motor housing until the holes in the housing are aligned

with the holes in the cutting head casting. Insert the four M5 x

25mm long screws and washers then tighten.

5. Insert the brushes and compress the spring then

insert the plastic brush caps and tighten brush cap

until snug. Do not over-tighten! Over-tightening will

damage the brush cap.

6. Slide the motor air intake cover over the motor housing and align the

screw holes in the intake cover with the holes in the cutting head.

Insert the M4 x 16mm long screws and washers into the back of the

air intake housing and tighten.

7. Insert the air filter into the air motor intake housing. Do not ever

operate machine without Air Filter.

NEVER ATTEMPT ANY OF THE INSTRUCTIONS WITH POWER CONNECTED TO SAW!