Afinia 3D H440 Manual de início rápido - Página 4

Procurar online ou descarregar pdf Manual de início rápido para Impressoras 3D Afinia 3D H440. Afinia 3D H440 5 páginas.

Imprimir página
Install Filament Spool
1\
Put one spool of lament on the spool
holder ① at the back of the printer.
3\
In the "Material" interface of the
touchscreen, click the material button in
the circle switching among di erent types
of Filaments. Choose the lament that you
would like to use.
5\
Gently press the end of the lament into the extruder inlet and
push it to the end. When the temperature of the nozzle reaches
the preset temperature, the printer will beep and the extruder will
automatically grab the lament, and pull it in and extrude it through
the nozzle.
2\
Pull one end of the lament, feed the
lament through the lament feeding system ②
on the upper right at the back of the printer,
and pull the lament close to the extruder.
Note
: When pulling the
wire, make sure that
the lament spool turns
counterclockwise.
4\
After material selection, click the Extrude
button in the Material interface. The nozzle
starts being heated, and the heating progress
will be displayed on the upper left of the status
bar.
4
Load and Print Models
1\
Connect the printer to a computer
via USB.
Connect the power cord and turn on the
power switch on the back of the printer.
3\
Click the "Build" button on the main
menu to open the print interface, then
click
to load the STL.
2\
Start the A nia Studio2.X software.
One the top area, the software shows
the Serial Number of the machine, nozzle
temperature, print bed temperature, and
material type.
420860
38.18
36.58
PLA（Afinia)
4\
Use the Print Navigator to adjust the
3D model.
5