Highlander MAGNOPHONIC Manual - Página 3
Procurar online ou descarregar pdf Manual para Amplificador de instrumentos musicais Highlander MAGNOPHONIC. Highlander MAGNOPHONIC 4 páginas. Pickup and preamp for the tricone resophonic guitar
Imprimir página
M a g n op h o n i c I N S TA LL AT I O N
M a g n o p h o n i c I N S TA L L AT I O N
Listen to the instrument. If there are no apparent problems continue with the installation. In the event of a string buzz or other
1
Preparation
problem, deal with this first then continue with the installation.
Remove the strings and cover plate. Remove the cones and 'T' bridge, carefully place them out of harm's way.
An easy method of removing and replacing the strings and cover plate:
Release the tension on all the strings.
Place a piece of masking tape over the nut and the string retaining
holes in the tail piece.
Carefully remove the screws holding the cover plate.
Unscrew the strap nut and remove the tailpiece, cover plate and
strings, carefully placing them to one side of the guitar while leaving
the strings on the tuning pegs.
5
Install Preamp
Install the Preamp on the neck stick using the
clamps, screws and washers as indicated.
Install the Output Jack.
Secure the Output Cable to
the back of the Tricone
.
with Velcro
®
6
Mount Pickup
Secure the Mounting Stud to the pan using
the replacement screw.
Thread the pickup cable through the 3/16"
hole and slip the Pickup onto the mounting
stud, pushing it down onto the pan.
Secure the Pickup in place by tightening
the 'set screw' in the base of the Pickup.
Please don't over-tighten the 'set screw'.
The information and graphics contained in this document are the property of Highlander Musical Audio Products. Copying of any kind is prohibited, except for personal use only.
This Unique, Magnophonic Pickup and Preamplifier System was
designed specifically for the National Resophonic Tricone Guitar.
Pickup
Pickup
Cable
Replacement
Pan Screw
Mounting Stud
(for the pickup)
3
Remove Screw
2
Drill Hole
Output
Cable
An RCA Connector is used to connect the pickup to the preamp.
This connector was chosen for its 100% shielding, large contact
area (providing a very low noise connection) and long term
resistance to corrosion.
Bare Copper Shield (Ground)
The Red wire has been stripped and
twisted with the Bare Copper Shield.
Drill a 3/16" (4.5mm) hole for
2
the pickup cable.
Remove sharp edges.
Remove the existing 'Pan
3
Screw'.
Drill a 3/8" (9.5mm) hole for
4
the Output Jack.
Alternatively, the Jack can
be mounted in one of the grill
holes.
PAN
Heatshrink
Pin
White Wire
Cable Clamp
Clamp onto the Heatshrink
©
Highlander Musical Audio Products 1991-2009
Output
Jack
4
Drill Hole
7
Solder RCA
Cover
Pickup Cable