DCS CT-365BK Manual de instalação - Página 10

Procurar online ou descarregar pdf Manual de instalação para Campânula de ventilação DCS CT-365BK. DCS CT-365BK 15 páginas. Professional 5 burner 36” drop-in cooktop
Também para DCS CT-365BK: Manual de utilização e cuidados (18 páginas), Manual de instalação (20 páginas)

Imprimir página

CARE AND MAINTENANCE

CLEANING THE BURNERS:

For proper lighting and performance keep, the burners clean. It is necessary to clean the burners if

they do not light although the igniter clicks, whenever there has been a severe boil over or when the

flame doesn't burn blue.

Be certain all burner knobs are in the

position before attempting to clean the burners.

The burners have been designed for ease of

cleaning. When the grates and burners are cool,

remove the grate. The Burner Cap and the Brass

Port Ring can easily be lifted off. Wash these parts

in hot soapy water, rinse and dry thoroughly. The

Burner Caps are porcelain enamel, follow the

directions on page 9 that were given to clean the

burner grates. A bristle brush can be used to clean

out the toothed burner ports, if necessary.

Disassembly of the Simmer Ring is not

recommended, however, it

necessary to do so if the ports remain clogged

after normal cleaning. If it is necessary to

disassemble the Simmer Ring from the Base,

remove the Hex Nut at the top of the Simmer

Ring. Clean the Simmer Ring with hot soapy water

using a soft wire or plastic bristle brush then dry thoroughly. Re-assemble the parts using the Hex Nut.

After cleaning, it is important to make sure the Locating Pin on the bottom side of the Simmer Ring is

properly aligned with the corresponding hole in the Base and that the Locating Pin (see insert) in the

bottom side of the Brass Port Ring is properly aligned with the Locating Notch on the top side of the

Simmer Ring. Incorrect alignment will produce a potentially dangerous flame and poor burner

performance. See the illustration above.

CLEANING THE IGNITERS:

Be certain all burner knobs are in the

wipe with a water dampened cotton swab and be careful not to damage the igniter.

COOKTOP BURNER

OFF

Brass Port

Ring

Locating

Notch

Locating

may

become

Locating

Pin Hole

Inside

OFF

position before attempting to clean the igniters. Gently

IGNITER

Hex Nut

Simmer

Ring

Center Burner Base shown

Cap

Brass

Port

Ring

Base