HighPoint HPT370 Manual de instalação - Página 12
Procurar online ou descarregar pdf Manual de instalação para Hardware informático HighPoint HPT370. HighPoint HPT370 16 páginas. Ata raid controller for red hat linux
HPT370/372/372A Red Hat Linux Installation Guide
should automatically load the HPT37x2 driver.
2. If you use a SCSI adapter to boot the system, you cannot do as above since this may
conflict with other SCSI devices. However, you can add the driver to the existing
RAM disk image. First check which image file you are using by checking the
" initrd=" line in file /etc/lilo.conf, then use the following commands (we assume the
file is /boot/initrd-2.4.2-2.img. For Redhat 7.2 system, just need to substitute
" initrd-2.4.2-2.img" with " initrd-2.4.7-10.img" to get the default RAM disk file
name):
# gzip – dc /boot/initrd-2.4.2-2.img > /tmp/initrd.ext2
# mkdir /mnt/initrd
# mount – o loop /tmp/initrd.ext2 /mnt/initrd
# cp hpt37x2.o /mnt/initrd/lib/ (specify the correct location of hpt37x2.o here)
Now, add a line " insmod /lib/hpt37x2.o" to the file /mnt/initrd/linuxrc, just
below the line of insmoding SCSI adapter' s kernel module. Example of linuxrc:
... ...
echo "Loading scsi_mod module"
insmod /lib/scsi_mod.o
echo "Loading sd_mod module"
insmod /lib/sd_mod.o
echo "Loading aic7xxx module"
insmod /lib/aic7xxx.o
insmod /lib/hpt37x2.o
echo "Loading jbd module"
... ...
# umount /mnt/initrd
# gzip – c /tmp/initrd.ext2 > /boot/initrd-2.4.2-2.img
If you are using Lilo to boot your system, you also need to run lilo:
# lilo
Then reboot your system and the driver will be loaded.
Step 5 Configure System to Mount Volumes when Startup
Now you can inform the system to automatically mount the array by modifying the file
/etc/fstab. E.g. You can add the following line to tell the system to mount /dev/sda1 to
location /mnt/raid after startup:
/dev/sda1
/mnt/raid
ß
SCSI adapter' s kernel module
ß new inserted line
ext2
defaults
0 0
- 10 -