Dynavet MasterPlus PRO Manual - Página 6

Procurar online ou descarregar pdf Manual para Produtos para animais de estimação Dynavet MasterPlus PRO. Dynavet MasterPlus PRO 15 páginas. Dog training kit

Dynavet MasterPlus PRO Manual
GB
none. The traditional method consists of
throwing a metal chain down close to
the dog in order to interrupt him but this
method was only effective in 20% of
cases with respect to eating less than
15% of the bait and in 0% of cases if
the criterion was complete inhibition.
Do not dig, Do not chew
MasterPlus
®
PRO can also be used to
interrupt a dog that is chewing furniture
or digging up the garden. However,
always offer him an alternative like a
bone to gnaw on or an indestructible
toy to chew.
3 - What are the limitations of
the device?
MasterPlus
®
PRO has been scientifically
validated by experts in animal
behaviour. They have shown that most
failures in training of dogs with
MasterPlus
®
PRO occur for two
reasons:
1. Poor timing:
particularly the collar being set off too
late e.g. when the dog has already
made contact with the cyclist he is
chasing. Fortunately, disruptive stimuli
like the MasterPlus
®
PRO spray do not
harm the dog, even when they are used
inappropriately.
2. Habituation:
e.g. when the MasterPlus
®
PRO is set
off repeatedly, in the wrong context.
This diminishes the surprise effect of
the gas release.
It is best to be able to know your dog's
signals, so that you can interrupt bad
behaviour at the moment it occurs.
It is also advisable not to tackle all your
dog's misbehaviours at the same time.
Rather, concentrate on one at a time,
the worst first.
II - User instructions
1- Getting started
with the spray collar
Before using MasterPlus
®
PRO
Your dog should not see you preparing
the MasterPlus® PRO for action, other-
wise he will become collar-cued.
Exclude your dog when practising with
the collar and remote control, when
filling the spray reservoir and when
changing the battery.
1- Securing
the
strap
(see figure 2)
- Secure the strap around the
MasterPlus
®
PRO by sliding it through
the two lugs.
- Place the loop on the strap
- Slot the end of the strap in the black
buckle to form a collar
- Adjust the collar around your dog's
neck. It should be possible to run your
finger between the dog's neck and the
strap.
- If you wish, cut the extra length of
strap with scissors and burn the cut
edge to prevent it from fraying.
- Push the rest of the strap through the
loop.
Caution: do not do this while the dog is
wearing the collar or his hair might
catch fire!
2- Filling up the reservoir
(see figure 3)
- Place the unit upside down on a flat,
solid surface. The white part (with the
filling valve) must be uppermost and
facing you.
- Direct the refill so that the metal tip is
pointing downwards.
- Insert the tip into the filling valve
(same operation as for filling a lighter)
while maintaining the device
- Press canister firmly downwards for
10 seconds
- Release pressure
- Do this again for 10 seconds. This
operation must be repeated until the
tank is full.
- Check the level in the tank by tipping
the unit. The liquid level can be seen
against light.
Caution: never fill the device while the
dog is wearing it as this will frighten the
dog and could damage the filling valve.
3- Inserting the battery
(see figure 4)
- Unscrew the battery cover, using the
token. Slide the battery into the slot,
"-" (negative end first). The "+"
(positive end) should then be against
the battery cover (facing outwards).
- Screw the cover back on, using the
token and applying slight pressure on
the battery.
- For easy use of the collar, it is advised
to keep the token carefully by slipping
it onto the remote control strap.
4-
Using
the
collar
- Switch the device on by putting the
red strip of the remote close to the
one on the collar for 4 to 5 seconds. A
single tone will then be emitted. If
nothing happens do not hesitate to try
- 5 -
a wider contact surface around the
two red strips until your hear the tone.
- Code the collar by pressing one of the
3 buttons shortly until you hear 3
short successive tones.
- Your collar is now exclusively
synchronized with the remote used
for its coding and ready for use.
To switch the device off, put the
red strip of the remote close to the one
on the collar until you hear
2 successive tones. Do not hesitate to
try a wider contact surface around the
two red strips until your hear the
2 tones. The collar will memorise
the code. If you switch it back on, it is
ready for use immediately. Switching
it off will save battery power.
However in order to optimise
battery life, it is advised to remove
the battery in case of prolonged
inactivity.
Note: The collar-receiver will not
remember the code if the battery is
removed for more than 15 seconds. To
re-synchronize the collar again, just fol-
low the above steps.
5- Fitting the collar
(see figure 5)
- Secure the strap around the dog's
neck, the nozzle directed upwards
towards the nose.
- Tighten the collar gently, leaving
space for two fingers between your
dog's neck and the MasterPlus
®
PRO:
the spray must be directed forward,
towards his muzzle.
- For dogs with long hair, the collar
should be lengthened so that the
spray nozzle is clear of the coat!
Alternatively the hair could be
trimmed.