adeptus 6+2 Drawer Wide Roll Cart 76169 Manual de instruções de montagem - Página 5
Procurar online ou descarregar pdf Manual de instruções de montagem para Mobiliário de interior adeptus 6+2 Drawer Wide Roll Cart 76169. adeptus 6+2 Drawer Wide Roll Cart 76169 8 páginas. Matte black/white finish
Imprimir página
2
ATTACH THE SIDES TO THE CROSSBARS
ATTACH ONE SIDE FIRST AND THEN THE OTHER.
DO NOT STAND LEFT SIDE (PART 3) UP
•
ON THE EDGE YET. TO EASE ASSEMBLY,
LAY SIDE FLAT ON THE FLOOR, RUNNER
SIDE VISIBLE.
MATCH UP BACK CASTER SUPPORT
•
(PART 6) AND FRONT CASTER SUPPORT
(PART 7) AT DOWEL HOLES LOCATED AT
THE BOTTOM OF SIDE
• PLEASE CHECK THAT THE DISTANCES
MATCH TO THE SQUARE DIAGRAM.
SECURE BACK CASTER SUPPORT (PART 6) TO THE LEFT
•
SIDE (PART 3) USING SCREW (PART C).
SEE THE ROUND DIAGRAM, A BLOW UP IMAGE OF THE SCREW
POSITIONING TROUGH THE ANGLED POCKET HOLES.
SECURE FRONT CASTER SUPPORT (PART 7) WITH SCREWS
•
(PART C) TO THE LEFT SIDE (PART 3) IN THE SAME MANNER.
CAREFULLY TURN LEFT SIDE (PART 3) TO ITS BACK EDGE,
•
AS SHOWN IN THE DIAGRAM.
POSITION RIGHT SIDE (PART 2) TO LINE UP THE CROSSBARS
•
(PART 6 AND 7) AT THE DOWEL HOLES AT BASE OF THE RIGHT SIDE
(PART 2).
SECURE CASTER SUPPORTS (PART 6 AND 7) TO RIGHT SIDE
•
(PART 2) USING SCREW (PART C) AND SHOWN IN THE DIAGRAM. TIP:
HAND TIGHTEN FOR THE BEST FIT.
ATTACH (PART 5) MIDDLE CROSSBAR TO BOTH SIDES OF
•
THE UNIT AT THE SIDE DRILLED HOLE.
DO NOT USE A DRILL. HAND TIGHTEN.
3
ATTACH THE TOP
• LINE UP THE DOWEL HOLES IN TOP (PART 1)
WITH DOWELS THE IN UNIT´S SIDES.
• SEE ROUND DIAGRAM:
SLIDE (PART C) SCREWS THROUGH ANGLED
POCKET HOLES.
AND HAND TIGHTEN FOR BEST FIT.
TIP: Turning the
unit upside
down provides a
better angle to
tighten the
screws.
C= 6
Screw 4,0 x 30mm
.
2
3
1
5/8
CONTAINED
c
c
5
c
c
7
c
c
6
TIP: This
C= 6
step is
easier with
two people.
Screw 4,0 x 30mm
C
C